Traceable 1051 Owner's manual

SPECIFICATIONS

Capacity: 23 Hours, 59 Minutes, 59 Seconds.

Resolution: 1/100th second (> 30 minutes)

1 second (< 30 minutes)

SINGLE ACTION TIMING

1. Press the MODE button until the unit displays the

 stopwatchmode(indicatedbyaashingbarunderSU).

2. Press the LAP/SPLIT/RESET button to clear the display

to zero.

3.TherstpressoftheSTART/STOPbuttonstartsthe

 stopwatchtiming.

4.ThesecondpressoftheSTART/STOPbuttonstopsthe

 stopwatchtiming.(FlashingbarsunderFRandSA

 indicatethattiminghasbeenstopped).

5.Afterthetimeisrecorded,presstheLAP/SPLIT/RESET

button to clear the display to zero. RESET will only clear

 thedisplaytozeroafterthestopwatchhasbeenstopped.

TIME-IN/TIME-OUT TIMING

1. Press the MODE button until the unit displays the

 stopwatchmode(indicatedbyaashingbarunderSU).

2. Press the LAP/SPLIT/RESET button to clear the display

to zero.

3.TherstpressoftheSTART/STOPbuttonstartsthe

 stopwatchtiming.

4.ThesecondpressoftheSTART/STOPbuttonstopsthe

 stopwatchtiming.(FlashingbarsunderFR,SA,andSU

 indicatethattiminghasbeenstopped).

Thestopwatchwillholdthereadingwherestopped(Time-Out).

5.ThethirdpressoftheSTART/STOPbuttonstartsthe

stopwatch at the point that it was previously stopped

 (Time-In).

AnynumberofTime-In/Time-Outintervalsmaybetaken.

6.Attheendofthetimingpress,theSTART/STOPbuttonto

stop the stopwatch, record the time, and then press the

LAP/SPLIT/RESET button to clear the display to zero.

RESET only clears the display to zero when the stopwatch

has been stopped.

LAP/SPLIT TIMING

Lap/splittimingfreezesthedisplayforpartialtimeswhilethe

internalclockcontinuestorunandmeasurethetotalelapsed

time.EachpressoftheLAP/SPLIT/RESETbuttoncaptures

thelap/splittimeordisplaysthecumulativerunningtime.

1. Press the MODE button until the unit displays the

 stopwatchmode(indicatedbyaashingbarunderSU).

2. Press the LAP/SPLIT/RESET button to clear the display to

zero.

3.TherstpressoftheSTART/STOPbuttonstartsthe

 stopwatchtiming.

4.TherstpressoftheLAP/SPLIT/RESETbutton“freezes”

 thedisplayforrecordingatimewhiletheinternalclock

 continuestorun.(TheblinkingbarsunderTH,SA,andSU

 indicatetheinternalclockisrunning.)

5.ThesecondpressoftheLAP/SPLIT/RESETbutton

 “releases”thedisplay.Thedisplayisinstantlyupdatedto

 thecumulativerunningtime.

6.SuccessivepressesoftheLAP/SPLIT/RESETbuttonwill

 “freeze”or“release”thedisplay.

Anynumberoflap/splitsmaybetaken.

7.Attheendofthelastevent,presstheSTART/STOPbutton

to stop the stopwatch and press the LAP/SPLIT/RESET

button to clear the display to zero. RESET only clears the

display to zero when the stopwatch has been stopped.

Whilethestopwatchisrunning,twofasttimescanbe

capturedbypressingtheLAP/SPLIT/RESETbuttonrstand

theSTART/STOPbuttonsecond.Theblinkingbarsunder

TH,SA,andSUindicatetheeventtimeisstoppedandthe

displayisshowingthe“frozen”lap/splittimeoftherstevent.

“Release”thedisplaybypressingtheLAP/SPLIT/RESET

buttonagain.TheblinkingbarsunderFR,SA,andSUindi-

catetheeventtimeisstoppedandthedisplayisshowingthe

cumulative total time. Press the LAP/SPLIT/RESET button to

clear the display to zero.

CONTINUOUS TIMING

Fortimingwhichlastsforover24hours,thestopwatch

instantly rolls over to zero when the maximum display is

reachedandcontinuestiming.Simplymakenoteofthedays

that have elapsed.

SETTING TIME-OF-DAY/DATE

1.PresstheMODEbuttonuntiltheunitdisplaystheclock

mode.

2.PressandholdtheMODEbuttonfor3seconds.Theunit

 willdisplaythealarmtimewiththehourdigitsashing.

3.PresstheMODEbuttonagain.Theunitwilldisplaythe

 time-of-daywiththesecondsashing.

4. Press the LAP/SPLIT/RESET button to set the seconds to

 zero.(Ifthesecondsareabove30,thenpressing

LAP/SPLIT/RESET will reset the seconds to zero and

advance the minutes by one).

5.PresstheSTART/STOPbuttonandtheminuteswillash.

6. Press the LAP/SPLIT/RESET button to advance the

minutes.

Note:Pressingthebuttonasingletimewilladvancethedisplayby

one, press and hold the button to advance the display rapidly.

7. Repeat steps 5 and 6 to set hours, month, date, and day.

Note:Whensettinghours,anAorPtotherightthetimeindicates

AM/PM time.

8.Whennished,presstheMODEbuttontorecordthe

 changesandreturntotheclockmode.

Todisplaythedate,whileintheclockmode,pressandhold

the START/STOP button.

Todisplaythetimein24-hourformat;whileintheclock

mode,whilepressingandholdingtheSTART/STOPbutton,

presstheMODEbutton.EachpressoftheMODEbuttonwill

togglethetime-of-daydisplayfromAM/PMto24-hourtime.

TRACEABLE

JUMBO-DIGIT

STOPWATCH

INSTRUCTIONS

SETTING TIME-OF-DAY ALARM

1.PresstheMODEbuttonuntiltheunitdisplaystheclockmode.

2.PressandholdtheMODEbuttonfor3seconds.Theunit

 willdisplaythealarmtimewiththehourdigitsashing.

3. Press the LAP/SPLIT/RESET button to advance the hours.

4.PresstheSTART/STOPbutton.Theminuteswillash.

5. Press the LAP/SPLIT/RESET button to advance the

minutes.

6.PresstheMODEbuttontorecordthechangesandreturn

 totheclockmode.

Todisplaythealarmtime,whileintheclockmode,pressand

hold the LAP/SPLIT/RESET button.

ACTIVATE/DE-ACTIVATE

TIME-OF-DAY ALARM AND HOURLY CHIME

Thetime-of-dayalarmandhourlychimemaybeactivatedin-

dependentlyofeachother.PresstheMODEbuttonuntilthe

unitdisplaystheclockmode.Whilepressingandholdingthe

LAP/SPLIT/RESETbutton,eachpressoftheSTART/STOP

buttonwilltogglethroughthefollowingsettings:

HourlyChimeActivated-

 icon will appear on the display

Hourly Chime and Time-of-Day Alarm Activated-

 and

)

icons will appear on the display

Time-of-Day Alarm Activated-

)

icon will appear on the display

Hourly Chime and Time-of-Day Alarm De-Activated-

No icons will appear on the display

Withthetime-of-dayalarmactivated,whenthealarmtimeis

reached,thealarmwillsoundforoneminuteandthenauto-

maticallyturnofftopreservethebatterylife.Asoundingalarm

maybeturnedoffbypressingtheLAP/SPLIT/RESETbutton.

With the hourly chime activated, a chime will sound at the top

ofeveryhour.

ALL OPERATIONAL DIFFICULTIES

Ifthisstopwatchdoesnotfunctionproperlyforanyreason,

replacethebatterywithanewhighqualitybattery(see

“BatteryReplacement”section).Lowbatterypowercan

occasionallycauseanynumberof“apparent”operational

difculties.Replacingthebatterywithanewfreshbatterywill

solvemostdifculties.

BATTERY REPLACEMENT

Afaintdisplay,incorrectdisplay,ornodisplayareallindica-

tors that the battery must be replaced. To replace the battery,

removethescrewsonthebackoftheunit.Removethe

back.Removethescrewonthebatteryclip.Removethe

exhaustedbatteryandreplaceitwithanew3-voltlithium

CR2032sizebattery.Makecertainthenewbatteryisin-

stalled with the positive side visible. Replace the battery clip

andtightenthescrew.Replacethebackoftheunit.Replace

thescrewsandtightensecurely.

WARRANTY, SERVICE, OR RECALIBRATION

For warranty, service, or recalibration, contact:

CONTROL COMPANY

12554 Old Galveston Rd. Suite B230

Webster, Texas 77598 USA

Ph. 281 482-1714 • Fax 281 482-9448

E-mail [email protected]

www.traceable.com

Control Company is ISO 9001:2008 Quality-Certied

by DNV and ISO/IEC 17025:2005 accredited as a

Calibration Laboratory by A2LA.

Control Company Cat. No. 1051

Traceable

is a registered trademark of

Control Company.

Traceable 1051 Owner's manual

Related papers

Other documents