Borum Industrial CH16NT Maintenance Guide

Brand
Borum Industrial
Model
CH16NT
Type
Maintenance Guide

This manual is also suitable for

SB July23 www.tqbbrands.com.au Page 1 of 1
Borum Drill Presses
Safety Trip Switch
Calibration Guide
Safety Trip Switch Troubleshooting Guide (not starting on first startup)
Borum Drill Presses – Calibration Guide.
1. Ensure unit is disconnected from the mains power & then open the belt & pulley cover.
Inside is a safety trip switch that activates if the lid is opened in use which shuts the machine
down.
2. During transport, the adjuster for the trip switch may have shifted or become loose
causing the fitting and the trip switch not to connect. If you aren’t hearing a clicking
noise from the switch when opening or closing the lid, this will need to be adjusted.
3. When installing the chuck guard into the channel guide, there is a second trip switch embedded
into the channel which activates if the guard is opened while the machine is in operation. When
installing the guard, it is essential for the cut groove to be in the correct position as circled.
4. Now that you have followed the above troubleshooting, your Borum Drill Press will be correctly
configured & work as per manufacturers specifications.
DISCONNECT THE DRILL PRESS FROM THE POWER SOURCE PRIOR TO
ANY MAINTENANCE PERFORMED
  • Page 1 1

Borum Industrial CH16NT Maintenance Guide

Brand
Borum Industrial
Model
CH16NT
Type
Maintenance Guide
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents