2. EVO Manufacturing
  3. EVO-1113B

EVO Manufacturing EVO-1113B Installation guide

  • Hello! I have analyzed the installation instructions for the EVO MFG JK Front Shock Relocation Kit EVO-1113B. This document provides step-by-step instructions on how to install the relocation brackets, along with details on the included components and drilling sizes required. I am ready to assist you with any questions you have about the installation process.
  • What size should the existing hole on the side of the factory coil spring perch be enlarged to?
    What size should the reward hole on the underside of factory shock mount be enlarged to?
    What size hardware is used for the side bolt of the relocation bracket?
    What size hardware is used for the shock installation?
EVO-1113B
EVO MFG JK Front Shock Relocation Kit
QTY PART# DESCRIPTION__________________
1 EVO-760003 BOX 10x4x4
1 EVO-11092B PASS LWR B/O C/O MOUNT
1 EVO-11092DB DRVR LWR B/O C/O MOUNT
1 EVO-770046 HARDWARE PACK
1. Remove lower shock bolt and remove shock out of factory bracket.
2. Turn the steering wheel to provide access to drill on the side of the factory
coil spring perch.
3. Enlarge the existing hole on the side of the factory coil spring perch to
11/32” .
4. Enlarge reward hole on the underside of factory shock mount to 7/16” .
5. Loosely install the EVO MFG Front shock relocation bracket (DO NOT
TIGHTEN at this point). 2 Bolts on the underside of the factory shock
mount with 3/8” hardware and side bolt with 5/16” hardware.
6. Install shock into EVO relocation bracket using the provided ½” hardware and
tighten shock with all other bolts loose.
7. Tighten all other bracket mounting hardware.
8. Repeat these steps for other side of the vehicle.
/