1
Outdoor
GP I :ENERAL RODUCT NFORMATION
This product is safety listed for wet locations.
This product may be dimmed with a low voltage electronic dimmer.
This instruction shows a typical installation.
1
2
1A
3
2
4
5
Installation Instructions for
Londontowne Outdoor Post (LED)
1.1
OL11307_OL11308-LED
OL11307, OL11308-LED
Connect the fixture to a suitable ground in accordance to local electrical codes.
Connect the white fixture wire to the neutral power line wire with a wire nut.
Connect the black fixture wire to the hot power line wire with a wire nut.
Secure the fixture to the post with the post screws making sure to neatly tuck in all wiring.
Install all glass panels by carefully sliding them into the fixture and securing them using the clips.
Secure the frame to the fixture using the frame screws.
Place the cover over the frame and secure it in place by screwing the finial onto the nipple.
POST
POST SCREW
3
6
7
44
CAUTION - RISK OF FIRE
This product must be installed in accordance with
the applicable installation code by a person familiar
with the construction and operation of the product
and the hazards involved.
Use minimum 90°c supply conductors.
COVER
CLIP
GLASS PANEL
5
5
FINIAL
NIPPLE
FRAME SCREW
FRAME
FIXTURE
FIXTURE
6
7
6
Page is loading ...
Page is loading ...
4
SAVETHESE INSTRUCTIONS!
7400 Linder Ave, Skokie, IL 60077
800.969.3347
www.Feiss.com
© 2015 Feiss.All rights reserved.The "Feiss" graphic is a
registered trademark of Feiss. Feiss reserves the right to
change specifications for product improvements without notification.
A Generation Brands Company
/
