Global Direct 13865 Installation guide

HANGING INSTRUCTIONS

Damage may occur if the hanging hardware packed with this item is not

used.

This Item comes with tested sawtooth hardware attached to the back of

the frame and a screw and anchor pack that meets the weight

requirements.

Please use 1/4” drill bit to drill hole into wall at desired location.

Put the anchor into the drilled hole and insert screw into anchor allowing

the screw to protrude 3/8” from wall.

Space the screws on the wall so that they align with the hanging

hardware that is attached to each side of the frame back. This will give

even distribution of weight and a safe installation.

To hang item, place the attached sawtooth hanger on the back of the

frame over the screw.

This will give even distribution of weight and a safe installation. The

wall anchor and screw included with this item has been tested by

installing the screw in a ½ inch thick Gypsum Wallboard (Sheetrock).

Hitting a wall stud is not necessary to safely hang.

Care Instructions

Wipe with a soft dry cloth.