For Technical Support:
For Technical Support:For Technical Support:
For Technical Support:
Call our Technical Service Department
Monday through Friday, 9 a.m. to 5 p.m. (EST)
1-800-832-8697
customer_support@enablingdevices.com
Finger Switch #717
USER’S GUIDE
50 Broadway
Hawthorne, NY 10532
Tel. 914.747.3070 / Fax 914.747.3480
Toll Free 800.832.8697
www.enablingdevices.com
A wearable switch for persons with limited mobility. Designed in the bio-
engineering labs at The University of Rhode Island. Switch can be
customized to fit the user's specifications. Size: 1½" x ½". Weight: 1 oz.
Operation:
Operation:Operation:
Operation:
1. Attach the Switch to your finger by adjusting the Velcro strap
around your finger so it has a firm fit. Please note you can remove
the Velcro strap and place it to 90 degrees from its present
location. Bend the end of the wire so that the thumb or other
fingers can activate it. Please Note:
Please Note:Please Note:
Please Note: take care when bending
take care when bendingtake care when bending
take care when bending
wire, excessive force will cause damage to the unit
wire, excessive force will cause damage to the unitwire, excessive force will cause damage to the unit
wire, excessive force will cause damage to the unit. Do not
bend the wire within 1" of the switch housing. Refer to figures 1
thru 4 for proper setup.
2. Connect an external device via the 1/8"cord jack on the unit
Connect an external device via the 1/8"cord jack on the unitConnect an external device via the 1/8"cord jack on the unit
Connect an external device via the 1/8"cord jack on the unit.
. .
. If
If If
If
you use a ¼ " to 1/8" adaptor, it mus
you use a ¼ " to 1/8" adaptor, it musyou use a ¼ " to 1/8" adaptor, it mus
you use a ¼ " to 1/8" adaptor, it must be a mono adaptor, not
t be a mono adaptor, not t be a mono adaptor, not
t be a mono adaptor, not
stereo.
stereo.stereo.
stereo.
3.
3.3.
3. Applying slight pressure to the Finger Switch’s metal activation arm
will cause activation of your device. Activation will only be
maintained under sustained pressure of the switch.
Figure 1
Figure 1Figure 1
Figure 1.
. .
.
Figure 2.
Figure 2.Figure 2.
Figure 2.
Troubleshooting:
Troubleshooting:Troubleshooting:
Troubleshooting:
Problem:
Problem:Problem:
Problem: The Finger Switch does not activate a connected device.
Action #1:
Action #1:Action #1:
Action #1: Make sure all connections are tight.
Action #2:
Action #2:Action #2:
Action #2: Check batteries in your device, replace if weak or dead.
Care of Unit:
Care of Unit:Care of Unit:
Care of Unit:
The Finger Switch can be wiped clean with any household multi-purpose
cleaner and disinfectant.
Do not submerge
Do not submergeDo not submerge
Do not submerge the unit, as it will damage the contents of the top and
the electrical components.
Rev
Rev Rev
Rev 4/21/17
4/21/174/21/17
4/21/17
-
1
-
2
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
Other documents
-
Vermeiren Navix User manual
-
-
Invacare Action 2000 User manual
-
Invacare esprit action4 NG User manual
-
-
-
-
-
Invacare Action 4 Series User manual
-