SHINE DECOR
RF Dimmer Pairing and Unpairing Instructions
When the remote is not working and LED is flashing in an uncontrolled way, it’s probably because
the remote is inadvertently paired to a nearby object and become unpaired from the controller.
Remote Pairing
1. switch off the power
2. hold down the brightness up button for 5 seconds
3. switch on the power
4. led start flashing showing your remote is now fully paired to the controller
5. try the remote to see if it's working
Remote Unpairing
1. switch off the power
2. hold down the brightness down button for 5 seconds
3. switch on the power
4. led start flashing showing your remote is now unpaired from the controller
5. try the remote to see if it’s working
NOTE: you can use one remote to control several lights once you’ve paired this one remote to
each controller individually. You can also use individual remote to control individual controller.
/
