C2G 41313 Owner's manual

Brand: C2G

Model: 41313

Type: Owner's manual

Installation:

Transmitter

1- Connect the power adapter (provided) to an electrical outlet.

2- Connect the adapter cable to the DC IN input connecter located on the

transmitter rear panel.

3- Use an RCA to 3.5 mm cable (provided) to connect the transmitter and your audio

sources. NOTE: RCA plugs must be connected for proper operation.

Receiver Headphones

1- Remove the battery door from the left hand side (L) of the headphones.

2- Insert two rechargeable AAA size batteries, taking care to ensure proper polarity.

3- Replace the battery door.

4- Switch off the receiver headphones and place them on the transmitter to charge the

batteries for 24 hours before initial use.

Operation:

1- Turn on the headphone receiver by pressing the ON/OFF button, and turn on the

transmitter by switching to channel 1, 2 or 3 on the back of the transmitter.

2- If the LED (red) on the headphones is OFF, place the headphones back on the

transmitter for recharging; as the power level of the batteries is low.

3- If the LED (red) on the headphones is ON, then you can connect your desired audio

source with the transmitter.

4- Press the AUTO SCAN button on the headphones to automatically connect to the

transmitter (green LED will light on the headphones)

5- If interference is heard or no connection is made, switch between channels 1, 2, or 3 on

the transmitter and press the AUTO SCAN button on the headphones to reconnect.

6- Turn OFF the transmitter and then the headphones when finished with use.

Note:

To both protect the transmitter and save power, the headphones will turn OFF

automatically if there is no audio signal from the transmitter within 4 minutes.

Charging the Batteries:

1- Switch OFF the headphones.

2- To recharge the headphone batteries, place the headphones in the transmitter, ensure

that the charge contacts touch the transmitter’s charge pins and the CHARGE LED

lights up green when charging. Remove and replace the headphones if the LED does

not light.

3- The charge process starts immediately and the LED becomes darker when the

charging process is finished.

4- Be sure to charge new batteries for 12 hours before using them for the first time in the

headphones.

Note:

The batteries must be fully charged before first use. An initial 24 hour charge is required to

guarantee an acceptable service life for the rechargeable batteries. Always ensure that the

headphones are switched to the OFF position while the batteries are charging.

Important:

This unit should be operated with rechargeable batteries only. When replacing the

batteries or when disposing of the unit always comply with applicable laws relating to the

disposal of batteries. Please place them in a proper disposal container to ensure that they

are eliminated safely and in an environmentally-friendly way.

Specifications:

Operating voltage 2.3V - 3.0V

Operating time 8 hours (charged 24 hours)

Max. power output 5.0 mW

Frequency response 40 Hz - 11 KHz

S/N 65 dB

Operating distance 50 meters

Trouble Shooting:

NO SOUND

• Ensure that the adapter is pushed fully into the power outlet and that it’s cable is properly

connected to the DC IN 6V connector on the transmitter.

• Ensure that the headphones ON/OFF switch is switched “ON”.

• Ensure the transmitter is switched ON to channel 1, 2, or 3.

• The headphones battery charge level may be too low. Recharge the batteries or replace

them with fully charged batteries.

• Ensure that your DVD, TV set, stereo system or audio component is switched on and set

to a channel that broadcasts an audio signal.

• Use the headphones volume control to increase the sound level (only when in use as a

wireless headphone).

• The audio signal input level is too low. Increase the volume from the audio source of

stereo, CD, TV, etc.

• The connected audio/video equipment may not be in playback mode. Start playback on

by the equipment.

• The headphones output level is set too low. Adjust the volume to a suitable level.

DISTORTION

• The headphones battery charge level may be too low. Recharge the batteries or replace

them with fully charged batteries.

• Ensure that the volume setting is correct.

• The headphones may be too far away from the transmitter.

• Ensure the red/white RCA plugs or connected to the transmitter.

FCC

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant

to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful

interference in a residential installation.

This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in

accordance with the instructions, may cause harmful interference to radio communications. However,

there is no guarantee that interference will not occur in a particular installation.

If this equipment does cause harmful interference to radio or television reception, which can be

determined by turning the equipment off and on, the user is encouraged to try to correct the interference

by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for additional suggestions.

Any changes or modifications not expressly approved by the party responsible for compliance could void

the user’s authority to operate the equipment. Where shielded interface cables have been provided with

the product or specified additional components or accessories elsewhere defined to be used with the

installation of the product, they must be used in order to ensure compliance with FCC regulation.

IC Statement:

Operation is subject to the following two conditions: (1) this device may not cause interference, and (2)

this device must accept any interference, including interference that may cause undesired operation of

the device.

“This product may contain chemicals listed in Proposition 65

(http://www.oehha.ca.gov/prop65/prop65_list/Newlist.html) that may be known to cause cancer, birth

defects or other reproductive harm.”

Introduction:

Enjoy your tunes more freely with these extreme

sound Soul 900 MHz wireless headphones. Fully

rechargeable and includes all you need to enjoy

your music time after time. Perfect for hooking up

to any audio device including your TV for wireless

enjoyment.

Features:

• Operation distance up to 50 m

• Up to 8 hours operation time

• Fully rechargeable with docking cradle

• Quality stereo sound

• Rechargeable batteries included

What’s included:

• Wireless transmitter docking base

• Wireless headphones

• Power adapter

• 3.5 mm to RCA audio cable

• 2 rechargeable AAA batteries

• Instruction manual

ON OFF

OPEN

VOL.

AUTO SCAN

1- Battery door

open

2- Power ON/Off

switch

3- (Red) Power

indicator

4- Battery door

5- Auto scan

button

6- (Green) Auto

scan indicator

7- Volume +/-

DC IN 6V

AUDIO

CHANNEL

OFF

Red: power/charge

ON/OFF/Channel

selector

RCA audio in

Adapter jack

900 MHz WIRELESS HEADPHONES

www.audio-unlimited.com

www.cablestogo.com

C2G 41313 Owner's manual

C2G 41313 Owner's manual

Other documents