Wolf 804383 Installation guide

Wolf
Brand
Wolf
Model
804383
Type
Installation guide

This manual is also suitable for

INSTALLATION
NOTICE: Depending on the model, additional bezels may
be included with this kit but not utilized.
1 Remove knobs (if installed) then remove existing bezels
by extracting two screws from each bezel. Refer to the
illustration below.
2 Remove new bezels from packaging and discard
packaging material then install new bezels with existing
screws.
3 Reinstall knobs. Using the chart as reference, identify
the icon etched next to each bezel to determine the cor-
rect placement. For dual fuel ranges, refer to the illustra-
tion below for oven selector bezels placement.
4 If any of the knobs "stick" when pressed, remove the
knob and slightly loosen the two bezel screws. Refer to
the illustration below. Once the proper alignment has
been achieved, tighten screws and reinstall knob.
CAUTION
Do not place bezels in dishwasher. Do not soak or use
abrasive cleaners. To clean, wipe with a damp cloth and
mild detergent and water; rinse and dry.
Icon Text On Knob
Hi-Low and Simmer Hi-Low
100°F to 450°F
Off and Hi
Off and Hi
ICON
BEZEL
SCREW
Bezel placement.
Oven selector knob.
(dual fuel range only)
NYLINER
OVEN SELECTOR KNOB
Bezel Installation Instructions
wolfappliance.com 800.222.7820
page 1 of 1
9006431 REV-A 07/2015
  • Page 1 1

Wolf 804383 Installation guide

Wolf
Brand
Wolf
Model
804383
Type
Installation guide
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents