Wolf 822193 Installation guide

Type
Installation guide

This manual is also suitable for

page 1 of 1
Gas Range Knob Installation
wolfappliance.com 800.222.7820
821184 REV-C 03/2015
INSTALLATION
Depending on the model, additional knobs may be included
with this kit but not utilized.
1 Remove knobs from the packaging and discard pack-
aging material. Insert into the bezel as shown in the
illustration below.
2 Using the chart as reference, identify the icon etched
next to each bezel to determine the correct placement
of each knob (oven bezels do not have an icon). Once
proper placement has been determined, discard any
additional knobs.
3 If any of the knobs stick when pressed, remove the knob
and slightly loosen the two bezel screws. Refer to the
illustration below. Once the proper alignment has been
achieved, tighten screws and reinstall knob.
NOTICE: Do not place knobs or bezels in dishwasher.
Do not soak or use abrasive cleaners. To clean, wipe with
a damp cloth and mild detergent and water; rinse and dry
.
ICON
BEZEL
SCREW
Knob placement
ICON KNOB
Hi-Low and Simmer Hi-Low
Off and Hi
100°F- 450°F
Off and Hi
Oven 150°F- 500°F and Broil
18" Oven
(48" model only)
150°F- 500°F
  • Page 1 1

Wolf 822193 Installation guide

Type
Installation guide
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI