Atlantis A08-C100 Quick start guide

Type
Quick start guide

This manual is also suitable for

BARCODE SCANNER
A08-C100 (V2.0)
A08-LN1200
A08-LS1500
Symbologies setting
- Enable - Disable
Factory standard default settings
Items
Default setting
Interface
HID USB
Language (Keyboard)
English
Reading mode
Good read off
Terminator
CR
RS232 baud rate
Data bits
Stop bits
Priority
9600
8 bits
1 stop bit
None
Code ID
Off
Accuracy
Read 1 time
Emulate external keyboard
Disable
Enable 1D symbologies
UPC-A , UPC-E
EAN13, EAN8
Code39, Code93
Code128, Codabar
ENGLISH
Quick Start
Guide
www.atlantis-land.com
Check Version
Output Character Parameters Terminator
The factory default terminator is CR
Interface selection
The scanner is designed to switch easily from interfaces.
Remember to reset the interface before changing to PS/2
or RS232 cable. No presetting is requested for USB
interface. Scanning the barcode after the cable is changed
and activate the scanner by plugging again the cable.
* KEYBOARD
RS-232
USB
How Do You Program Scanner?
1. Scan Start Configuration
2. Scan all necessary able for parameters that
Meet your application
3. Scan end configuration to save to save the changes.
Resetting The Standard Product Defaults
If you aren’t sure what programming options are in your scanner,
or you’ve changed some options and want the factory settings
restored, scan the bar code below.
Interface Selection
The scanner is designed to switch easily from interfaces.
Remember to reset the interface before changing to PS/2 or
RS232 or USB cable.
Emulate External Keyboard
Scan the barcode below if you do not have an external keyboard.
After scanning the Emulate External Keyboard bar code, you must
power cycle your computer.
Language For Keyboard Interface
Scanning Mode Selection
Terminator selection Keyboard & USB
RS-232 communication setting
- Baud Rate
- Data bit
- Stop bit
- Parity
None
* CR
Tab
CR+LF
* Good Read Off
Trigger On/off
Flash/auto power on
Multi-Language Support
* US
Start Configuration
End Configuration
Standard Product Default Setting
KEYBOARD
RS-232
* HID USB
Continuous/Trigger off
Continuous/auto power on
Flash Mode
1200bps
4800bps
19200bps
2400bps
*9600bps
38400bps
7 bits
8 bit
enable
* Disable
* 1 stop bit
2 stop bit
* none
odd
even
mark
Space
Interface selection
Reading mode
Language ………etc.
USB Com Port Emulation
  • Page 1 1
  • Page 2 2

Atlantis A08-C100 Quick start guide

Type
Quick start guide
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI