7
11. GAIN SELECTOR SWITCH
Gaincanbechangedin6steps(0,−3,−6,−9,−12,and−15dB).
TheGainselectorswitchsetsthemicrophonesensitivitymaximumat“0
dB”positionandminimumat“−15dB”position.
Ifaloudvoicedistortstheoutputsound,decreasethesensitivitybysetting
theswitchtothe“−3dB”positionorlesswiththesuppliedscrewdriver.
Note: TheInputsensitivitysettingswitchisfactory-presetto"0dB."
12. TEST MODE ON/OFF SWITCH
• HoldingdowntheTestmodeON/OFFswitchfor1secondormorewith
thesuppliedscrewdrivercausesthetestsignaltobetransmitted.(This
condition is referred to as the Test mode.) Press this switch again to
returntotheusualcondition.
Note: Donotpresstheswitchtoostronglywithasharp-pointedobject,
as this may cause unit failure.
• Oncethepoweristurnedoff,thetestmodewillbereleasedthenexttimethepoweristurnedon.
• Whileintestmode,thereceiverdoesnotoutputaudiosignalsevenifitreceivestheradiosignalsfromthe
wireless microphone.
• For the test signal operation, refer to the S-D7000 Digital wireless system’s Setting software instruction
manualsuppliedwiththeS-D7802Digitalwirelessreceiver.
13. TROUBLESHOOTING
Symptom Point to check Remedy
Thebatteryindicatornot
lightevenifthepowerswitch
turnedon.
Batterypolaritynotcorrect. Reinsertbatteriescorrectly.
Batterydischarged. Replacethebatterieswithnewones.
When the power switch
turnedon,thebattery
indicatorashesred.
Batterydischarged. Replacethebatterieswithnewones.
When the power switch
turnedon,thebattery
indicatorashesgreen.
Group or channel set to the
onenotlistedinthefrequency
table.
Reset the group or channel according to
the“Frequencytable.”
Receiver’sreceivingantenna
indicatornotlightevenwhen
thepowerswitchturnedon.
(Nosignalreceived.)
Group,channel,andIDsetfor
the wireless microphone not
identical to those forwireless
receiver.
Reset the Group, channel, and IDfor the
wireless microphone to the same ones for
wirelessreceiver.
Interferes with other wireless
microphonebeingused
simultaneously.
Group and channel not set
according to the “Frequency
table”(p.12).
Check the “Frequency table” (p.12), then
resetgroup andchannelaccordingtothe
table.
Two wireless microphones set
to the same ID number.
SetthedifferentIDnumber.
Distance between the wireless
microphones too close.
Keepthewirelessmicrophonesatleast50
cm away from each other.
Wireless microphone being
usedtooclosetothereceiving
antenna.
Keepthewirelessmicrophoneatleast3m
awayfromthereceivingantenna.
Thereceivedaudiosignals
distortedoraudioleveltoo
low.
Gain selector switch not set
correctly.
SettheGainselectorswitchappropriately
while monitoring receiver’s audio output
levelmeter.
GAIN
0
−15
−12
−3
−6
−9
TEST