Sennheiser E 614 User manual

E 614
Sennheiser
Brand
Sennheiser
Model
E 614
Category
Microphones
Type
User manual

This manual is also suitable for

e 614
Instruction manual
e 614 | 2/7
Delivery includes
Delivery includes
• e 614
• MZQ 100 microphone clamp
• pouch
• quick guide
• safety guide
Product overview
2
1
1. Sound inlet basket
2. XLR-3 connector
e 614 | 3/7
Installation
Installation
Attaching the microphone
f Screw the microphone clamp to a stand.
f Place the microphone with its back end into the microphone clamp.
f Orient the microphone together with the microphone clamp.
Connecting the microphone
f Connect the XLR-3 socket of the microphone cable (optional accessories) to the XLR-3 socket of
the microphone.
Using the windshield
f Place the MZW 64 (optional accessories) windshield over the microphone head.
e 614 | 4/7
Operation
Operation
Positioning the microphone: Drums / Percussions
Attention: When closing the hi-hat, a strong air current is created on the edge. If the microphone is
positioned too close to the edge, interfering noise due to the air current can occur.
f It is vital to observe the following notes:
Position Resulting sound Commentary
A Natural, clear sound Position the microphone a few centimetres above the
outer edge of the hi-hat aiming down. If necessary,
remove unwanted low-frequency signal portions by
high pass filtering.
B More fundamental, little
overtones
A B
Positioning the monitor loudspeakers
f To prevent feedback and crosstalk, postion your monitor loudspeakers in the angle area of the
highest cancellation of the microphone (approx. 135°).
135°
e 614 | 5/7
Cleaning and maintaining the e 614
Cleaning and maintaining the e 614
CAUTION
LIQUIDS CAN DAMAGE THE ELECTRONICS OF THE PRODUCT!
Liquids entering the housing of the product can cause a short-circuit and damage the electronics.
f Keep all liquids away from the product.
f Do not use any solvents or cleansing agents.
f Disconnect the products from the power supply system and remove rechargeable batteries and
batteries before you begin cleaning.
f Clean all products only with a soft, dry cloth.
e 614 | 6/7
Specifications
Specifications
Transducer principle pre-polarised condenser microphone
Frequency response 40 - 20,000 Hz
Pick-up pattern super-cardioid
Sensitivity (free field, no load) 3 mV/Pa
Nominal impedance (at 1 kHz) 50 Ω
Min. terminating impedance 1 kΩ
Max. sound pressure level (at 1 kHz) 139 dB
Equivalent noise level
A-weighted
CCIR-weighted
24 dB(A)
35 dB
Phantom powering 12 - 48 V
Connector XLR-3
Dimensions ⌀ 20 x 100 mm
Weight 93 g
Polar pattern
30°
0°
180°
150°
120°
60°
90°
0
5
10
15
20
25
dB
30°
0°
180°
150°
120°
60°
90°
125 Hz
250 Hz
500 Hz
1,000 Hz
2,000 Hz
4,000 Hz
8,000 Hz
16,000 Hz
Frequency response
dBV
50
100
200
500
1,000
2,000
5,000
10,000
20,000
Hz
- 50
- 60
- 70
- 80
- 90
- 40
0°, 1 m
e 614 | 7/7
Overview of applications
Connector assignment
12
3
+
+
12
3
1
2
3
+ +
1
2
3
+
+
XLR
6.3 mm
XLR
XLR
XLR
BALANCED
Overview of applications
Primary application
Secondary application
•••• •
••
• •••
••
• ••
••
• • ••• •
•• • •• • • •
•• •
•• •
•• •
• • •
•• •
••
• •••
••
• • ••• •
••
••• •
• • • •• • • •
• •
• •
• •• ••
e 602 II
e 604
e 608
e 609
silver
e 614
e 835
e 845
e 865
e 901
e 902
e 904
e 906
e 908
e 914
e 935
e 945
e 965
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7

Sennheiser E 614 User manual

E 614
Sennheiser
Brand
Sennheiser
Model
E 614
Category
Microphones
Type
User manual
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents