Laura Ashley PX2414 User guide

Brand: Laura Ashley

Model: PX2414

Type: User guide

Laura Ashley PX2414 is a complete pendant lighting fixture that can help you achieve the desired ambiance in your home. With its adjustable cord length, you can customize the height of the pendant to suit your needs. The fixture is easy to install, and the assembly instructions provide clear and concise steps to guide you through the process. Before installing the fixture, remember to turn off the power at the main fuse or circuit breaker box for safety. The PX2414 is compatible with a variety of bulbs, so you can choose the wattage and color temperature that best suits your lighting needs.

WARNING: BE SURE TO SHUT OFF POWER AT THE MAIN FUSE OR CIRCUIT

BREAKER BOX BEFORE INSTALLING OR SERVICING THIS FIXTURE.

NOTE: Before installing, consult local electrical codes for wiring and grounding requirements.

Assembly Instructions

Camden Complete Pendant # PX2414

1. Thread two screws through the mounting strap, then secure them

with two lock nuts. Adjust the length of the screws if necessary.

2. Attach the mounting strap to the outlet box by using two mounting

screws.

3. Thread the cord through the spider of the shade, attach the nipple

of the socket to the spider and secure it with the center pipe.

4. Unscrew two set screws and remove the cord strap from the

grounding bracket. (See Fig.1)

5. Measure the desired length of the cord (A) from the canopy to the

top end of the center pipe. Leave additional 8" cord (B) above

the canopy, then cut off the unnecessary cord. (See Fig.2)

6. Mark the 3" cord (C) from the top of the cord. Use a knife to peel

off the insulation of the cord (C) carefully to show three inside

wires out. (See Fig.2)

Caution : Cutting too deep may cut off three inside wires and

destroy the insulation surface of the three inside wires.

7. Peel off the three wires from the top at about 5/8" length(D) to

expose the copper for wiring.

8. Reset the cord to the grounding bracket and fasten it with the cord

strap and the set screws. (See Fig.1)

9. Pull out the outlet wires and house grounding wire from the outlet

box. Make wire connections with wire nuts:

---The black wire from the fixture to the black wire from the

power source.

---The white wire from the fixture to the white wire from the

power source.

---The green wire from the fixture to the house grounding

wire from the power source.

* Carefully put the wires back into the outlet box.

10. Attach the canopy to the mounting strap by inserting the screws,

then secure it with the bolt nuts.

11. Install a bulb (not included). Note relamping label at socket or

packaging area for maximum allowed wattage.

12. Attach the rubber pad and the light shield to the harp by inserting

the nipple, then secure them with the finial.

13. Turn on the power at the main fuse or circuit breaker box.

Outlet Box

House Grounding Wire

Wire Nut

Screw

Canopy

Bolt Nut

Center Pipe

Spider

Socket

Harp

Nipple

Finial

Light Shield

Rubber Pad

Shade

Cord

Mounting Strap

Lock Nut

Mounting Screw

Cord

Black Wire

White Wire

Green Wire

Canopy

B (8")

D (5/8")

C (3")

Fig.2

Cord

Cord Strap

Set Screw

Grounding Bracket

Canopy

Fig.1

Laura Ashley PX2414 User guide

Laura Ashley PX2414 User guide

Laura Ashley PX2414 User guide

Related papers

Other documents