Kobalt 101100-53-01 Installation guide

Type
Installation guide

This manual is also suitable for

ITEM #0691031; 0691032; 0691033; 0691034;
0691035; 0691036; 0691037
MODEL #101100-9-01; 101100-53-01;
101101-9-01; 101102-9-01; 101103-9-01;
101104-9-01; 101104-53-01
SADDLE BOX
Kobalt
®
is a registered trademark
of LF, LLC. All Rights Reserved.
ATTACH YOUR RECEIPT HERE
Serial Number
Purchase Date
Questions?
PACKAGE CONTENTS
WWW.KOBALTTOOLS.COM
AB15505
SADDLE BOX
SADDLE BOX
Truck Box
Keys
×2
WWW.KOBALTTOOLS.COM
NOTES / REMARQUES / NOTAS
KEYS
ZINC PRIMER
VINYL TAPE
Call Customer service at 1-888-356-2258 (3KOBALT),
8 a.m. – 8 p.m., EST, Monday ‒ Friday.
WWW.KOBALTTOOLS.COM
ASSEMBLY INSTRUCTIONS
1. LOCATE IN TRUCK BED.
With the truck on a level surface,
place truck box into position on
truck bed. Use tape measure to
center box across truck bed.
Make sure the cover opens fully
without interference.
2. ATTACH BOX TO TRUCK BED.
NO DRILL METHOD using
KOBALT
®
Mounting Kit (Item 691045, sold separately):
Use J-bolts and washers as shown in gure. Place the J-
bolts up from the bottom through the mounting slots in the
sides of the truck box and around the bed lip. If your truck
bed is constructed of aluminum, place vinyl tape strips be-
tween the end of each J-bolt and the bed rail before tighten-
ing with wrench.
1
5/16 NUT
5/16 WASHER
TRUCK BOX
BED LIP
J-BOLT
VINYL TAPE (IF NECESSARY)
5/16 NUT
5/16 WASHER
TRUCK BOX
BED LIP
5/16 NUT
5/16 WASHER
NYLON WASHER (IF NECESSARY)
J-BOLT (NO DRILLING METHOD)
2
5/16 NUT
5/16 WASHER
TRUCK BOX
BED LIP
J-BOLT
VINYL TAPE (IF NECESSARY)
5/16 NUT
5/16 WASHER
TRUCK BOX
BED LIP
5/16 NUT
5/16 WASHER
NYLON WASHER (IF NECESSARY)
J-BOLT (NO DRILLING METHOD)
2
OPTIONAL DRILLING METHOD
OR
DRILL METHOD: Mark the top of the bed rail through the
mounting slots in the truck box (4 locations total). Drill 3/16
in. pilot hole and then 3/8 in. hole at each of these marks. If
your truck bed is constructed of aluminum, coat the drilled
holes with a zinc primer before securing with 5/16 in. nuts,
bolts, and at and lock washers (not provided) and tighten to
the truck bed.
ATTENTION: Read and understand all instructions and
warnings before operating or using this product. If contents
of the package are missing, do not return the product to
the store. Call Customer Service at 1-888-356-2258
(3KOBALT), 8 a.m. – 8 p.m., EST, Monday ‒ Friday.
SAFETY INFORMATION
PREPARATION
Kobalt
®
Mounting Kit (Item #0691045, sold separately),
is recommended for the no-drill installation method to the
bed rail lip.
Estimated Assembly Time: Approximately 30 minutes
Tools required: Ratchet wrench with extension and 1/2 in.
deep well socket, tape measure, safety glasses, gloves. A
marker/pencil and drill with 3/16 in. and 3/8 in. drill bits is
required to drill into the bed if using the drill method.
NOTE: If your pick-up is tted with a plastic drop-in bed liner,
it may need to be drilled, trimmed, or cut for proper installa-
tion of truck storage product.
Replacement keys are available. Locate & record the key
code on the front of the lock. Customer Service will need
this number to send you a replacement key set. There is a
$10 charge plus shipping and handling for replacement keys.
If your gas spring fails, you will need the item number lo-
cated on the registration decal on the underside of the truck
box lid when you call Customer Service to have the correct
item sent to you. Call Customer Service at 1-888-356-2258
(3KOBALT), 8 a.m. – 8 p.m., EST, Monday ‒ Friday.
SERVICE PARTS
This product carries a limited lifetime warranty to the original
purchaser, only, this product will be free from defects in mate-
rial and workmanship from the date of purchase and continu-
ing the expected lifetime of this product. If the product is
found to be defective in materials or workmanship, please call
1-888-3KOBALT, or return the item to the place of purchase
with a copy of the original sales receipt. The seller will, at its
option, replace the product. The remedy available for this
Warranty shall be limited to the cost of replacing the product,
and not for any other incidental, indirect, or consequential
damages. Any modication or unintended use of this product
shall immediately void all manufacturer’s warranties. Manu-
facturer disclaims all liability for injuries to persons or property
resulting from any modication to, or unintended use of these
products. This limited warranty expressly excludes:
Defects caused by normal wear and tear, cosmetic rust, scratch-
es, accidents, unlawful vehicle operation, or modication to the
product, or any types or repair of a Kobalt
®
Product other than
those authorized or provided by the Manufacturer.
• Defects resulting from conditions beyond the Manufac-
turers control including, but not limited to misuse, overload-
ing, or failure to assemble, mount or use the Kobalt
®
Product in accordance with the Manufacturers written
instructions or guide lines included with the Kobalt
®
Product
or made available to the original purchaser.
• Damage to the contents of the box or vehicle.
This warranty gives you specic legal rights, and you may
have other rights that vary from state to state.
WARRANTY
ARTICLE #0691031; 0691032; 0691033; 0691034;
0691035; 0691036; 0691037
MODÈLE #101100-9-01; 101100-53-01;
101101-9-01; 101102-9-01; 101103-9-01;
101104-9-01; 101104-53-01
BOÎTE À REBORDS
WWW.KOBALTTOOLS.COM
SADDLE BOX
SADDLE BOX
×2
KEYS
ZINC PRIMER
VINYL TAPE
KOBALT® is a registered
trademark of LF, LLC.
All rights Reserved.
Printed in the U.S.A.
JOIGNEZ VOTRE REÇU ICI
Numéro de série
Date d’achat
Des questions?
CONTENU DE L’EMBALLAGE
Boîte de camion Clés
Communiquez avec notre service à la clientèle au
1-888-3KOBALT (888-356-2258), entre 8 h et 20 h
(HNE), du lundi au vendredi.
Kobalt
®
est une marque de commerce
déposée de LF, LLC. Tous droits réservés.
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4

Kobalt 101100-53-01 Installation guide

Type
Installation guide
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI