2. GE
  3. BR Series
BR Series

GE BR Series Installation guide

  • Hello! I am an AI chatbot trained to assist you with the GE BR Series Installation guide. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
GE
Lighting
Installation Guide
imagination at work
Backlit Troffer Series
Diffuser Replacement
Description Code Corresponding Luminaires
22 diffuser Backlit Troffer 22 series
14 diffuser Backlit Troffer 14 series
24 diffuser Backlit Troffer 24 series
BEFORE YOU BEGIN
Read these instructions completely and carefully.
Save These Instructions
Use only in the manner intended by the manufacturer.
If you have any questions, contact the manufacturer.
WARNING/AVERTISSEMENT
RISK OF ELECTRIC SHOCK
• Turn power off before inspection, installation or removal.
• Properly ground electrical enclosure.
RISK OF FIRE
• Follow all NEC and local codes.
• Use only UL approved wire for input/output connections.
Minimum size 18 AWG (0.75mm
2
).
RISQUES DE DÉCHARGES ÉLECTRIQUES
• Coupez l’alimentation avant d’’inspecter, installer ou déplacer le luminaire.
• Assurez-vous de correctement mettre à la terre le boîtier d’alimentation électrique.
RISQUES D’INCENDIE
• Respectez tous les codes NEC et codes locaux.
• N’utilisez que des ls approuvés par UL pour les entrées/sorties de connexion.
Taille minimum 18 AWG (0.75mm
2
).
Specications
Diffuser Replacement Steps
IND126-081314
GE Lighting • 1-888-MY-GE-LED (1-888-69-43-533) • www.gelighting.com
GE Lighting Solutions, LLC is a subsidiary of the General Electric Company. The GE brand and logo are trademarks of the General Electric Company.
© 2014 GE Lighting Solutions, LLC. Information provided is subject to change without notice. All values are design or typical values when measured under laboratory conditions.
Place front bezel with diffuser on table. Unfasten
the two rail screws on the end rail with latches,
then remove this end rail.
3
Reattach end rail with screws.
5
1 2
Rotate latches to unlock the front bezel. Swing down panel and lift off front bezel with
diffuser.
Remove the old diffuser by sliding it toward the
side without end rail. Insert new diffuser, keeping
the round corner of diffuser on bottom right.
Locate round corner here
4
Hang panel on its hinges and swing up into place.
Rotate latches on front bezel to fasten it.
Note: Front side of diffuser should face outward.
6
NOTE: The following steps depict the 22 Series luminaire. However, the procedure is the same for the 14 and 24 Series xtures.
/