JayBird JB-BA-100I User manual

Brand: JayBird

Model: JB-BA-100I

Category: Mobile device dock stations

Type: User manual

JayBird JB-BA-100I is a Bluetooth adapter for iPod that allows you to wirelessly stream stereo audio to your JayBird JB-100 Bluetooth Stereo Headset from compatible iPod models. Once connected to your iPod's dock connector, the adapter draws power from the iPod, eliminating the need for batteries. With a range of up to 33 feet, you can enjoy your music without being tethered to your iPod.

Bluetooth

Stereo Headset

Bluetooth

Adapter for iPod

JB-BA-100i

User Manual

Please review your user guide carefully

before using this product

If you need further assistance DO NOT return it to the store

where you bought it, please contact us at:

1.866.244.3399

For additional troubleshooting information please visit us

on the web at:

www.jaybirdgear.com

and click on “reviews & support”

ENGLISH

Introduction:

The JayBird JB-BA-100i Bluetooth

Adapter for iPod

enables any compatible

iPod

(see list below) to transmit stereo audio to your JayBird JB-100

Bluetooth

Stereo Headset (up to a 33 foot range).

The JayBird Bluetooth

Adapter for iPod

is compatible with the following

iPod

models:

ENGLISH

The JayBird JB-BA-100i Bluetooth

Adapter for iPod

is powered by the iPod

once connected to the iPod

dock connector, so no batteries are required.

Pairing the adapter with your JayBird

Bluetooth

Stereo Headset

1. Before pairing, make sure that your headset is turned off (no ﬂashing blue

LED through the right side logo).

2. Put the headset into pairing mode by pressing the POWER/TALK button

on the headset for 5 seconds until the LED on the right earpiece begins

blinking alternating red and blue colors.

3. Plug the adapter into the iPod

dock connector located on the base of

your iPod

. The LED and JayBird name should be facing UP (same side

as the front of the iPod

)

4. Turn the iPod

on and start playing music. The adapter will activate and

respond to the streaming music by automatically searching for the JayBird

JB-100 Bluetooth

Stereo Headset. The LED on the adapter will be steady

blue color while it is in search mode, and then ﬂash blue once it start to

pair with the headset.

5. Once the headset ﬁnds and pairs with the adapter, both the adapter and

headset LEDs will blink blue (the headset will blink blue every six seconds

and the adapter LED will blink blue every 2 seconds). Your headset and

adapter are now paired.

Listening to Music

1. Once paired, the next time you connect the devices, just turn your headset

on by holding the power/talk button for 3 seconds until the LED on the right

earpiece ﬂashes blue, then plug the adapter to the iPod

dock connector

and play music. You will hear the music through your headset.

2. Adjust the volume by using the UP/DOWN buttons on the headset.

Adjusting the volume on the iPod

will have no effect.

3. When not using the adapter, it’s a good idea to remove it from the iPod

dock connector as it is drawing power from the iPod® and will reduce

the iPod

battery play time.

Using the phone call feature of your JayBird

Bluetooth

Stereo Headset

1. The JayBird Bluetooth

Stereo Headset can also be paired with any

compatible Bluetooth

enabled mobile phone. For pairing instructions,

refer to the user manual that came with your headset.

For a list of compatible A2DP enabled phones please visit www.jaybirdgear.com/phones

ENGLISH

2. Once paired with a mobile phone, you can make and receive phone calls

even while listening to music from your iPod

wirelessly using your

JayBird Bluetooth

Adapter. When a call comes in, you will hear the phone

ring. Answer the call by pressing the TALK button on the headset (or by

pressing the answer button on your phone) and the music will turn off

automatically and you can then take the call. When you done with the call

and the call has been terminated, the headset will switch back to music

play. (Refer to your JayBird Bluetooth

Stereo Headset user manual for

detailed instructions on making and receiving phone calls)

Technical Speciﬁcations

Protocol

Bluetooth

1.2, A2DP

Frequency Band

2.4 GHz

Tx Power

Bluetooth

Class 2

Range

10 meters/33 feet

Audio Format

16-bit Stereo

Music Playing Time

Draws power from iPod

Battery

No battery - draws power from iPod

Charging

No charging required - draws power from iPod

Weight: (Grams)

6.5g

Operating Temp

14 F to 113 F (-10° C to 45° C)

Storage Temp

-4 F to 131 F (-20° C to 55° C)

AC power supply

Not required - draws power from iPod

No of Paired Device

Pairing passkey

Not required - automatically pairs with headset

Features

Power and audio line out from iPod

. Status LED

Agency Approvals

FCC, CE

Included in Box

JayBird Bluetooth

Adapter for iPod

, User Manual

Compatibility

• iPod

nano 1st generation 1GB, 2GB, 4GB

• iPod

5th generation (video) 30GB, 60GB, 80GB

• iPod

nano 3rd generation (video) 4GB, 8GB

• iPod

nano 2nd generation 2GB, 4GB, 8GB

• iPod

classic 80GB, 160GB

• iPod

touch 8GB, 16GB

Page is loading ...

JayBird JB-BA-100I User manual

Brand: JayBird

Model: JB-BA-100I

Category: Mobile device dock stations

Type: User manual

Download PDF

report

in other languages

italiano: JayBird JB-BA-100I Manuale utente
français: JayBird JB-BA-100I Manuel utilisateur
español: JayBird JB-BA-100I Manual de usuario
Deutsch: JayBird JB-BA-100I Benutzerhandbuch

JayBird JB-BA-100I User manual

JayBird JB-BA-100I User manual

in other languages

Related papers

Other documents