ACDC Dynamics EPS-2000B User manual

Brand: ACDC Dynamics

Model: EPS-2000B

Type: User manual

This manual is also suitable for

EMERGENCY POWER SYSTEM

The EPS/CPS includes an inverter/charger/ power supply all-in-one unit.

It consists of an inverter charger and rechargeable batter y they are housed in a portable enclosure.

You can use it to power most of your electrical appliances at home when mains power is not available.

In addition, you can use it as a charger to re-charge other 12V sealed lead acid batter y.

Make sure the EPS is switched off before connecting to AC wall socket .

Use the AC power cord provided in the package.

Please remember to switch off the EPS before connecting on the electrical appliances to the outlet.

Plug the electrical appliance into the AC output socket (on the side panel) and switch the EPS on.

The appliance connected to the EPS will work.

When the EPS is connected to an AC wall socket, it is an AC source to power the electrical appliances connected.

At the same time, the battery is being recharged.

When he AC source is cut off, the battery powers the electrical appliances connected and the battery is discharged.

You are advised not to keep recharging the battery continuously when the battery is at full or 80% capacity.

Overcharging will make the battery damaged.

When full charged LED turn green, please remove the charger if long time not to use it.

User Manual

1. INPUT CABLE SOCKET

2. CHARGER ON/OFF SWITCH

3. FULLY CHARGED LED INDICATOR

4. CHARGER WORKING STATUS LED

5. INVERTER ON/OFF SWITCH

6. INVERTER WORKING STATUS LED

7. FAULT LED

8. OUTPUT SOCKET

9. NEGTIVE TERMINAL BLOCK FOR EXTERNAL BATTERY

10. POSITIVE TERMINAL BLOCK FOR EXTERNAL BATTERY

11. VENTILATION HOLE(1500W-3000W)

12. INPUT CABLE

13. USER MANUAL

14. FUSE

Note:

150W-6 00W

1500W- 3000 W

1. 1X65ah battery can be installed in 150-300W system.

1 x 100ah battery has been installed in 600-3000W system.

The batter y terminal block is used for extra batter y which will be parallel in the system

2. 150W-1000W with one AC output and 1500-3000W with dual output.

1. INTRODUCTION

4. MATERIAL INDICATION

3. MAIN CHARACTERISTICS

2. FEATURES

12V DC to 220- 240V AC Modified sine wave or pure sine wave output

Charger Function

Continuous Power up to from 150W-3000W

Overload protection

150W-1000W single AC output

1500W-3000W dual AC outlets for running multiple electrical appliances

Installed with maintenance free sealed lead acid batter y, extra battery can be added by terminal block

5. TROUBLE SHOOTING

Fuse burned

Contact Seller for repair or changed

PCB broken

Change battery or re-connect the

battery

Battery's defective or

poor connection

Unplug the fault load

Earth fault protection

Contact seller for repairing or change

Strong collision cause

the circuit loosen

Red and green

LED not lit

Red and green

LED lit

Change fuse or contact technical support

Use a larger battery or connect more

batteries in parallel to increase the

back up time

AC loads power

consumption is higher

than the rated power

Replace the battery

Battery is old or defective

Battery run time is less

than expected

Over temperature protection

Overload protection

Short circuit protection

Change the battery

Remove or reduce load, wait for EPS cooling

Remove or reduce load or use bigger powerEPS

Remove short circuit load

TROUBLE POSSIBLE CAUSE SUGGESTED REMEDY

Battery over discharge,

low battery protection.

No AC

output

Red LED lit, green

LED not lit or beep

sound alarm

Stop to use it or switch off the charger

AC input voltage under

EPS beep long time but

5.2. When public power on, the problem happened in bypass and charger mode.

TROUBLE

POSSIBLE CAUSE SUGGESTED REMEDY

Tighten connection or re-connect

the AC power

Poor AC wire connection

Change fuse or contact technical support

built in fuse burned

It will be auto stop the charge or

you switch off charger mode

Battery will be fully

charged soon

When the public power on,

inverter mode can't be

charger mode switch to

5.3. Other problem

TROUBLE

POSSIBLE CAUSE

SUGGESTED REMEDY

It will working when in

charge mode, after fully

charged it will auto stop

It is normal

When AC main power

failure, it should be working

in inverter mode, but it is

not work

Contact seller for repairing or

replace it

EPS series unit output

waveform. Light noise

sounds it is normal

You can choose our CPS series

products with output waveform

pure sine wave

Used with sensitive loads,

there is light noise

Used with TV, radio snow

free or buzzing sound

Choose CPS series pure sine wave inverter with charger

Reading voltmeters can't

get accurate data

Use a true RMS reading

voltmeters

EPS output shows

low voltage

Cooling fan not working

Charge for the battery

Battery over discharge

Power dissipation caused by

the too long or thin cable

Use more shorter /wider DC cables

mode or adjust AC voltage

170V

still on working

Using time too long,

Switch off 10 minutes for cool

high temperature

5.1. When public power failure and Inverter switch ON, the problem happened in the inverter mode.

6. INSTALLATION

7. CAUTION

Ambient environment temperature below 40 degrees Celsius.

Store in a dry place, do not drip or splash water on the power inverter.

Do not place the EPS near a heating vent or any equipment which generates heat

Avoid dropping metal items or other objects on the EPS during operation.

They might spark or short circuit the battery or other electrical parts and may cause an explosion.

Do not place the EPS near flammable materials or in any location which may have flammable fumes or gases,

such as the batter y compartment of car

Ventilation: allow at least two inch of free space around the EPS for air flow/ heat release.

Make sure that someone is available to give assistance when you are using the EPS

Do not disassemble the EPS cabinet. Only qualified person can attempt to ser vice this product.

This product has no consumer ser viceable parts. Keep out of reach of children.

Do not put any object into the AC input socket except the AC power cord provided.

Keep the battery terminals clean. Regularly check all connections are secure & tight.

A loose connection can create high electrical resistance & generate excessive heat which is harmful to the product

The EPS shall not be used in connection with life suppor t systems or other medical equipment or devices.

The battery inside is sealed lead-acid type. Do not attempt to recondition it

Do not smoke, use matches, lighters or open flame while near batteries.

Do not place the EPS under direct sunlight.

PUBLIC POWER

BATTERY

AC LOAD

EPS UNIT

Extra 12V battery

1pc 12V, 100Ah battery inside

Note. After proper connection inverter and charger switch (5) and (2) and the LED display state belows:

Inverter

OFF/ON Switch(5)

Fault red LED(7) lit

Battery over discharge, low voltage or short circuit,

overload, short circuit protection function

SWITCH STATE

Inverter green LED(6) lit Battery in good condition, inverter is ready for use

LED INDICATION EXPLANATION

Charger

OFF/ON Switch(2)

Fully Charged red LED (3) lit

Charger green LED (4) lit

Battery has been fully charged.

Public power on, charger mode is working

Fault red LED (7) lit

Public power AC input is not in good condition

8. DISPOSAL

Old electrical appliances are recyclable. Do not dispose them in the domestic waste! Separately

deliver these in a valuable material collection point. Dispose the packing material environmentally

friendly. Please give cardboard and paper to the waste paper, foils to a valuable material collection

point.

Modified Sine Wave.

Pure Sine Wave.

CPS-150B

150W

300W

CPS-300B

300W

600W

EPS-150B

150W

300W

EPS-300B

300W

600W

EPS-1000B

1000W

2000W

EPS-1500B

1500W

3000W

220±10% 50Hz

Model

Rated Power

Surge Power

AC output

Wave form

Output

EPS-2000B

2000W

4000W

PP-3000

3000W

6000W

EPS-600B

600W

1200W

12V(10-15V) (Refer Product's Specification)

170-250V(220V) or 70-150V (110V)

Automatic Voltage Regulated

12V

5A 5A 5A 5A 10A 10A 15A

Constant Current, Constant Voltage, Floating Charge(Auto.3 Stage)

<8ms(Switch less than 5 times

within 1 minute)

160-200W 330-400W

160-200W

330-400W

630-700W

1100-1200W 1600-1700W

>60℃ auto. shutdown

Earth Leakage, Polarity Reverse, Over Voltage, Low Voltage, Overload,

Overheat, Short Circuit protection

DC Input

AC Input

AVR Protection function

Charge Way

Transfer time

Overload

Over Temperature

Other

Max.

Current

Protection

Function

Note: Specifications is subject to change without notices.

15A 15A

Input

Charger

2100-2200W 3200-3300W

Can be chosen(12ms or 500ms)

through dial switch.

9. SPECIFICATION

10. USAGE GUIDE

Resistive Loads

Selection: Choose inverter’s rated power a little higher than the load rated power.

E.g. Incandescent Lamp, Electric Iron, Printer, Stereo Equipment, etc.

Capacitive Loads

Selection: Choose Inverter’s rated power 2 times higher than the load rated power

E.g. CFL Lamp, Desktop Computer, Laptop, Television, LED Lamp, etc.

Inductive Loads

Selection; Choose Inverter’s rated power 5 times higher than the load rated power

E.g. Hari dr yer, Hand Drill, Pump, Fridge, Washing Machine, Microwave Oven, Air

Conditioner, Fan, etc

CAUTION

We do not warrant unit for any and all defects or damages caused by:

1. Incorrect wiring or installation of inverter, or direct connection to AC distribution

wiring leading to inverter being burnt out.

2. Shipping or transportation damages.

3. Breakdown or damage caused by physical damage.

4. Breakdown or damage caused by force majeure.

5. Exposure to unsuitable environmental conditions (such as rain, lighting strikes or

high humidity).

Please contact your dealer first before sending the faulty item back for ser vice

ACDC Dynamics EPS-2000B User manual

Brand: ACDC Dynamics

Model: EPS-2000B

Type: User manual

This manual is also suitable for

Download PDF

report

ACDC Dynamics EPS-2000B User manual

This manual is also suitable for

ACDC Dynamics EPS-2000B User manual

Other documents