Trademark Innovations GRNHSE-PRTBLE Operating instructions

Brand
Trademark Innovations
Model
GRNHSE-PRTBLE
Type
Operating instructions
MINI GREENHOUSE
ASSEMBLY INSTRUCTIONS
Construct the base frame using 6 pieces
of A, 4 G connectors in each corner and 2
D connectors in-between the long sides of
the base.
A – 12 Pieces - long straight piece
B – 6 Pieces - short straight piece
C – 6 Pieces - bent piece
D – 6 connectors
E – 2 connectors
F – 1 connector
G – 4 connectors (90 degrees)
H – 2 connectors //these are slightly more
bent (110 degrees)
PARTS LIST
TO ASSEMBLE
Step 1
Insert all 6 of the B pieces perpendicular
into the D and G connectors in the base.
Step 2
A
B
C
D E F G H
Begin to construct the roof by connecting 2 A
posts using the 1 F connector and putting the
2 H connectors on the outsides
Place 4 D connectors on each
corner so that the long side of
the connector is an extension of
post B.
Place 2 E connectors on two
inner B posts that you did not
place connectors on in step 3
Place 4 A post in-between the D
and E connectors.
Step 3
Step 6 Step 7
Step 4 Step 5
Insert the straight edge of all 6 C posts, into
roof connectors F and H.
Connect the curved piece of all 6 C posts into
the connectors left on the body of the green-
house
Step 8 Step 9
Place plastic covering over the greenhouse
making sure that the zippers are on the
roof of the greenhouse.
Tie strings on plastic cover to secure cover.
Step 10 Step 9
Your greenhouse is now assembled.
  • Page 1 1
  • Page 2 2
  • Page 3 3

Trademark Innovations GRNHSE-PRTBLE Operating instructions

Brand
Trademark Innovations
Model
GRNHSE-PRTBLE
Type
Operating instructions
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Other documents