Panduit WBH3 Installation guide

Hello! I am an AI chatbot trained to assist you with the Panduit WBH3 Installation guide. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!

INSTALLATION INSTRUCTIONS

NETWORK CONNECTIVITY GROUP

WORLDWIDE SUSIDIARIES AND SALES OFFICES

412 Rockwell Court

Burr Ridge, Illinois 60521

Technical Support: 866-405-6654

Fax: 708-444-6993

Web site: www.panduit.com/ncg

Page 1 of 1

CM23A

HINGED WALL MOUNT BRACKET

PART NUMBERS: WBH1, WBH2, WBH3, WBH4,

WBH2E, WBH4E, WBH6E

TO MOUNT BRACKET TO WALL OR 19” RACK:

1. Determine desired wall or rack mounting location.

2. Insert appropriate hardware (screws not included) through keyways in rear of bracket and

fasten securely to wall, or insert through round holes and fasten securely to rack..

3. Hinged bracket is removable so that equipment can hinge open on either side.

TO INSTALL EQUIPMENT ON BRACKET:

1. Determine desired mounting location for equipment.

2. Align equipment on bracket.

3. Insert #12-24 screws (not included) into equipment and screw into mounting bracket holes

on either side .

4. To access back of equipment, remove L-bracket screws.

NOTE: WBHE models are packaged without hinges or L-brackets installed. Mount hinges

and L-brackets on the outside of the Main Bracket as shown, using the supplied #12-24

screws and pem nuts.Make certain the pem nuts are facing the back of the Main Bracket.

L-Bracket for

quick access to

back of panels

Back opening for in wall

cable access

Main BracketHinged Bracket

Hinged Bracket

Screws

Cable Tie

or Tak-Ty

slots