134
Handle fixing
Section 4 - Kitchen installation - Handles
Finishing touches
Handle fixing
Follow the diagrams to ensure the handle positions are aligned throughout
the range and are positioned correctly.
We recommend you fit the frontals to the cabinets before you start marking
and drilling handle positions.
NOTE: Always check the drilling centres before any holes are drilled.
IMPORTANT: Be aware of handle clash situations in corner
configurations.
5mm
above
centre
5mm
above
centre
45mm
Centre
line
Centre
line
Centre
line
Centre line
Framed
drawer
== ==
==
Framed door Slab door
Application examples
Handle drilling centres
2.5mm
drill bit
Front
edge
5mm
drill bit
Back
edge
1. Measure the handle position on
the frontal.
NOTE: When marking drawer
fronts make sure holes are
5mm above the centre line of
the drawer as shown in the
application example.
2. Ensure all spike positions are
parallel.
3. Drill the frontal.
4. Secure the handle using the
screws provided.
Bumpons (x2)Screw cover cap 5mm Cover capHinge hole cover cap Self-adhesive cover cap
-
1
Howdens GIR3032 Operating instructions
- Type
- Operating instructions
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Other documents
-
Bosch HBH4601 Installation guide
-
Stratco Outback® Flat Installation guide
-
-
-
-
Trend SRT User manual
-
B&Q WALL Assembly Manual
-
-
-