ROOMS TO GO 18523464 Assembly Instructions

  • Hello! I'm a chat assistant that has reviewed the provided assembly instruction for UTTERMOST Chair model 23307. I understand the document outlines the step-by-step process for assembling the chair, including the parts list and tools required. I am ready to answer any questions you may have about the assembly process or the features of this chair based on the provided document.
  • What is the first step in assembling the chair?
    What type of bolts are used to attach the Front Legs?
    Do all bolts need to be tightened at once?
    What tool is needed to secure the Cross Bar?
    What tool is needed for the final tightening?
Put the Back Frame (1) and Seat Cushion (2) together, use one Short Bolt (S) to
fix the Back Frame (1) and Seat Cushion(2)in the Center, and use four Long Bolts
(L) to fix the two back legs. Do not tighten All the Bolts until Step (5) is
completed.
Attach the two Front Legs(6) into the holes on the Seat Cushion (2) and use four
Medium Length Bolts(M) to fix. Please note that the Left Leg label in Blue goes into
the Hole label in blue, and Right Leg label in Red goes into the Hole label in Red.
Do not tighten All the Bolts until Step (5) is completed.
1
2
6
1
2
6
Put the Left Side Stretcher (3) into the Left Hole of the back Frame, and the Left
Hole of the front Left Leg.And the same assembly for the Right Side Stretcher (4)
into the Right Hole of Back Leg, and the Right Hole of the front Leg.of the legs.
Please note that Blue and Red labels are used on the ends of the Stretchers and
the Holes.
Then use the Cross Bar (5) to connect the Left Stretcher(3) and the Right
Stretcher(4).Please make sure the screws holes of the stretchers are facing
DOWNWARD of the chair and the screw holes of the cross bar are facing BACKWARD of
the chair. Then use six Screws (G) to secure them. Screw Driver is needed here (not
included)
Then set the Chair on a flat surface, make sure all the Legs are in same Level and
then use the Allen Wrench(F) to tighten all the Bolts until secure.
Put the Cover On and the assembly is completed.
/