707 VCC181 User Manual/Instructions

Brand: 707

Model: VCC181

Category: Small kitchen appliances

Type: User Manual/Instructions

707 VCC181

This powerful vacuum cleaner combines a 21 kPa vacuum pressure and a 300 W suction power with a HEPA filter to trap even the smallest particles of dust and allergens. The variable suction control allows you to adjust the suction power to suit different surfaces and cleaning tasks. The telescopic tube and flexible hose provide a wide reach, ensuring effortless cleaning under furniture and in hard-to-reach corners. The floor brush features adjustable bristles for optimal cleaning performance on both hard floors and carpets.

707 VCC181

User Manual

& Instructions

Dual Cyclonic Vacuum

•This booklet should be retained by the user for future reference.

Please read all instructions carefully before operation.

•

VCC181

Page 1

SAFETY REGULATIONS

Warning:

When using any electrical appliance, always observe basic safety precautions.

The following instructions should be followed to reduce the risk of ﬁre, electric shock

or injury.

10.

11.

12.

13.

General:

Read this manual carefully before using the appliance. Keep this manual in a

safe place for future reference.

Use the appliance only as described in this manual.

Check if the voltage indicated on the device corresponds to the local voltage

before you connect the device.

Always use an earthed socket.

Check the device regularly for damage. Do not use the device in case the power

cord or plug is damaged, or when any component of the device has been

dropped or damaged. If the power cord is damaged, you must have it replaced

by an authorized service centre to avoid safety hazards.

Do not attempt to repair the device yourself.

This appliance is not suitable for use by children or persons with reduced physi-

cal, sensory or mental capabilities, or lack of experience and knowledge, unless

someone responsible for their safety is supervising them or explains how the

appliance must be used. Close supervision is required if the appliance is used

near children, pets or plants.

Never allow children to play with the PE packaging as there is risk of suocation.

Do not leave the device unattended when the plug is in the socket.

Always remove the plug from the socket when you clean the device or when you

are not using the device.

Never pull the power cord to disconnect the plug from the socket; instead, hold

the plug and gently pull to disconnect.

Do not use the device with an extension cord unless this extension cord has been

checked and tested by a qualiﬁed mechanic.

Do not pull or carry the device by its power cord and do not use the power cord

as a handle.

Page 2

14.

15.

16.

17.

18.

19.

20.

21.

22.

23.

24.

25.

26.

27.

28.

29.

Do not bend the power cord or pull it around sharp edges or corners. Do not pull

the device over the power cord and do not allow the power cord to be

compressed or curled.

Keep the device, the plug and the power cord away from ﬂames and hot surfaces.

Do not use attachments which are not recommended by 707, especially acces-

sories which are not supplied with the appliance.

Do not bend the exible hose or carry the device by the exible hose. Stop using

the device immediately when the exible hose shows damages.

Keep the end of exible hose, telescopic tubes and other suction openings away

from your face and body.

Do not insert anything into the air intake as it may cause blockage. Do not use the

device when the telescopic tube, exible hose or suction air intake is blocked.

Keep the device free of dust, lint, hair and anything that may reduce the air ﬂow.

Vacuuming large objects may cause the air passage in the telescopic tube or

exible hose to be obstructed. If this happens, remove the object that is stuck.

Do not vacuum anything burning or smoking, like cigarettes, matches or hot

ashes or any sharp objects, like glass or nails.

Do not vacuum toner content of printers or copying machines with the vacuum

cleaner.

Do not vacuum liquids or moist materials of any sort as there will be a high risk of

electric shock.

Never use the device in areas where certain vapours may be present (paint

thinner, ﬂammable material, oil based paint and varnish, ﬂammable liquids and

gases) to avoid risk of a possible explosion.

Do not use the device on wet surfaces.

This device is for household use only. Store the appliance indoors.

Never immerse the device and/or the power cord in water or other liquids.

Do not touch the device or the plug with wet hands.

Be cautious when vacuuming staircases or uneven surfaces.

Note: This appliance is only intended for domestic use; do NOT use it for

commercial purposes.

Page 3

1. PRODUCT SPECIFICATIONS

Product: Dual-Cyclonic Vacuum

Model No.: VCC181

Voltage: 220-240 V~ 50/60 Hz

Power: 1800 W

Suction Power: 300 W

Vacuum Pressure: 21 kPa

Noise Decibel: 79.4dB

2. PRODUCT PARTS

1. Flexible hose

2. Crevice tool

3. Furniture brush

4. Telescopic tube

5. Carrying handle

6. Dust canister

7. Wessel Werk© oor brush

8. Canister release button

9. On/o switch

10. Variable suction control

11. Cord winding switch

12. HEPA ﬁlter

13. Storage slot for oor brush

14. HEPA ﬁlter cover

9 8 11

Page 4

3. ASSEMBLY

• Remove all packaging materials.

• Clean the device, if necessary, with a wet cloth and some detergent.

• Make sure that all parts are clean and dry before assembling the device.

Warning: Do not insert the plug into the electrical outlet and do not turn the device on

before you have completed the assembly.

1. Insert the ﬂexible hose into the inlet on the main body of the device. The ﬂexible hose

is assembled correctly when it clicks into place.

2. Attach the telescopic tube to the ﬂexible hose.

3. Attach the suitable accessories (ﬂoor brush/crevice tool/furniture brush) to the

telescopic tube for different cleaning purposes.

4. OPERATION

Before use

Check the device for damage before each use. Do not use the device if the power cord

or the device is damaged or not working properly.

Warning: do not use the device without all ﬁlters and the dust canister in place.

1. Pull the power cord to a length between the yellow and red mark.

Note: do not pull the power cord to the red mark. This may damage the device.

2. Insert the plug into an electrical outlet.

3. Attach the ﬂoor brush or one of the following accessories to the end of the telescopic

tube.

Page 5

Floor brush:

The ﬂoor brush features a switch, which allows you to set the bristles in

or out.

Position 1: bristles are out. This setting is suitable for hard ﬂoors (wood,

laminate, tiles, stone, etc.).

Position 2: bristles are in. This setting is suitable for carpets, rugs and

soft ﬂoor covering.

Crevice tool:

The crevice tool is suitable for the cleaning of corners, ﬁssures, skirting

board and other places that are dicult to reach. The crevice tool can

be stored in the accessory holder on the telescopic tube.

Furniture brush:

The furniture brush is suitable for the cleaning of furniture, upholstery,

wall surfaces, curtains, etc. The furniture brush can be stored in the

accessory holder on the telescopic tube.

3. Attach the ﬂoor brush or one of the following accessories to the end of the telescopic

tube.

4. Turn on the device by pressing the on/o switch.

Note:

• Do not vacuum anything burning or smoking, like cigarettes, matches or hot ashes.

• Do not try to vacuum liquids or moist materials of any kind as there will be a high risk of electric shock.

• Do not vacuum any sharp objects, like glass or nails.

• Do not use the vacuum cleaner to drain away toner content from printers of copying machines.

Adjusting the suction power

The suction power can be regulated by adjusting the variable suction control at the back

of the device.

Page 6

Adjusting the telescopic tube

The telescopic tube can be lengthened or shortened by sliding the switch on the telescopic

tube forward.

Emptying the dust canister

The dust canister should be emptied when it is visibly full.

1. Turn o the device and pull the plug from the wall plug.

2. Push the canister release button to remove the dust canister from the unit.

3. Hold the dust canister above a bin and press the button to open the dust canister.

4. Close the dust canister and place it back on the unit.

After use

1. Turn o the device by pressing the on/o switch.

2. Press the cord winding switch at the back of the device in order to rewind the cord.

Page 7

5. MAINTENANCE & CLEANING

Note:

• Always switch o and unplug the device from the wall socket before cleaning the device

or carrying out maintenance.

• Never immerse the device and/or the power cord in water or other liquids.

Cleaning the dust canister and ﬁlters

The suction power of the unit reduces when the dust canister is too full or when the ﬁlters

are dirty. Therefore all ﬁlters have to be cleaned regularly.

1. Press the canister release button in order to remove the dust canister from the unit.

2. Hold the dust canister above a bin and press the button to open the dust canister.

3. Open the lid of the dust canister by turning the lid. The lid is marked with ‘lock’ and

‘unlock’.

Page 8

4. Take the parts apart as shown on the image below.

5. Clean the parts with lukewarm water and let them dry.

Note: do not use detergents to clean the ﬁlters.

Note: do not use heating sources (blow-dryer, heating, etc.) to dry the ﬁlters and do not

put the ﬁlters back into the device until they are completely dry.

6. Clean the dust canister with a damp cloth.

7. Put the parts back in the right order in the dust canister, as described below.

Step 1: Place the foam ﬁlter in the small plastic ﬁlter.

Step 2: Place the ﬁlter cassette on top of the foam ﬁlter.

Large Filter Small Filter Foam Filter Filter Cassette

Page 9

Step 3: Attach this assembly to the lid by turning it anti-clockwise.

Step 4: Attach the large plastic ﬁlter to the lid by placing it over the small plastic ﬁlter and

then turning it anti-clockwise.

Important: make sure that the angular shape on the large ﬁlter is adjusted with the ‘lock’ / ‘unlock’

marking on the lid.

Step 5: Place the lid with the ﬁlters in the dust canister and turn the lid anti-clockwise to lock it.

Note: do not put the ﬁlters back into the device before they have dried completely.

8. Put the dust canister back onto the device

‘lock/’unlock’

mark

Curve

Page 10

Cleaning motor ﬁlters

1. Press the canister release button in order to remove the dust canister from the unit.

2. Remove the motor ﬁlter from the device.

3. Clean the ﬁlter with lukewarm water.

Note: do not use detergents when cleaning the ﬁlter.

4. Shake the remaining water from the ﬁlter and let it dry.

Note: do not use heating sources (blow-dryer, heating, etc.) to dry the ﬁlter and do not put

the ﬁlter back into the device before it has dried completely

Cleaning HEPA ﬁlter

1. Push the button on top of the cover to open it.

Motor Filter

2. Remove the ﬁlter from the device. Use a brush (not included) to remove large particles

from the ﬁlter, or tap the ﬁlter a number of times. Then clean the ﬁlter with lukewarm water.

Note: do not use detergents when cleaning the ﬁlter.

3. Shake the remaining water from the ﬁlter and let it dry.

Note: do not use heating sources (blow-dryer, heating, etc.) to dry the ﬁlter and do not put

the ﬁlter back into the device before it has dried completely.

Cleaning the device

1. Switch o the device before cleaning it.

2. Clean the device with a damp cloth and some detergent if necessary. Dry thoroughly.

Note: never use abrasives, bleaching agents or steel wool to clean the device. This could

cause damage to the material.

Storage

1. Make sure that the device and the attachments are completely clean and dry before you

store them.

2. A storage slot can be found at the rear side of the device where the ﬂoor brush can be

kept for storage.

Page 11

Problem Possible cause Possible solution

Device does not

work

Plug is not properly plugged in the

wall socket

Put the plug in the wall socket again

Device has no

or very weak

suction power

Dust canister is not properly

assembled

Re-assemble the dust canister

Dust canister is full Empty the dust canister

One or more ﬁlters are clogged up Clean the ﬁlters

Flexible hose or hose outlet is

clogged up

Switch the device o

ﬀ

and take the

plug from the wall socket. Check for

blockages.

blockages

Dust is coming

from the device

Dust canister is not properly

assembled

Re-assemble the dust canister

Flexible hose is not properly

assembled

Assemble the exible hose in the

hose outlet

Dust canister is full Empty the dust canister

Power cable

cannot be

pulled out

Power cable is entangled Carefully pull the power cable in and

out a number of times and press the

button to wind up the cable

Power cable is

not fully wound

Power cable is entangled Carefully pull the power cable out

some length and press the button to

wind up the cable

TROUBLESHOOTING

Page 12

707 VCC181 User Manual/Instructions

Brand: 707

Model: VCC181

Category: Small kitchen appliances

Type: User Manual/Instructions

707 VCC181

Download PDF

report

707 VCC181 User Manual/Instructions

707 VCC181 User Manual/Instructions

Other documents