2. Dinan
  3. D193-0938 Handling Kit

Dinan D193-0938 Handling Kit User manual

  • Hello, I'm your assistant. I've reviewed the provided Installation Notes for the Dinan Handling Kit A90/A91. This document outlines the installation process, the components included (bumpstops), and crucial alignment specifications. It highlights that the kit is designed to be used with the Dinan Spring Set D100-0938. I'm ready to answer any questions you might have about this installation guide or its content.
  • What components are included in this kit?
    What is the required alignment setting after installation?
    What should I do with the Dinan boot on the bumpstops?
INS193-0938 Rev. 9/30/22
D193-0938 HANDLING KIT; A90/A91
INSTALLATION NOTES
Thank you for purchasing a Dinan Handling Kit. We have spent many hours developing this kit
to assure that you will receive maximum performance and durability with minimum difficulty in
installation. Please take the time to read these instructions and contact us if you have any
difficulties during the installation.
This kit is intended to be used with a companion Dinan Spring Set, p/n D100-0938. This kit
contains:
• (4) Bumpstops *
Please include these items when installing the Dinan spring set.
* Dinan’s bumpstops may include a plastic or rubber protective boot. Please remove the Dinan
boot and reuse the OE boot whenever possible.
Alignment:
• An alignment is required after installation.
• Set tire pressures to factory recommended values.
• All Dinan suspension alignments are done with full fuel tanks and no weight inside the
vehicle.
• Specifications are as follows:
FRONT:
Setting
Tolerance
Camber
-2.0°
± 0.42°
Caster
7.5°
± 0.5°
Total Toe
0.27°
± 0.07°
REAR:
Camber
-2.0°
± 0.08°
Total Toe
0.23°
± 0.07°
If you encounter any difficulties during the installation, or if these instructions are not clear to
you, please call Dinan's Technical Support Staff @ (800) 341-5480.
Happy Motoring!
/