2. Logan
  3. F300-6

Logan F300-6 Owner's manual

  • Hello! I have reviewed the Operating Instructions for the LOGAN Frame Gluing System F300-6. This document provides instructions on how to use the system with F62 accelerator and F61 glue. The guide includes safety information, application steps, and tips for achieving optimal results. I'm ready to answer your questions about this device, so feel free to ask.
  • How long does it take for the glue to fully cure?
    What should I do if the glue gets on my skin?
    What is the purpose of the slot in the plate?
Operating Instructions
1. Spray F62 accelerator on one side of frame (Fig. 1)
2. Apply F61 glue to other side of frame. (Fig. 2)
3. Align frame joint over slot in plate. (Fig. 3)
NOTE: Slot allows for glue overflow.
4. Press corners together for 10 seconds. Bond will be instant. Full
cure in 24 hours. (Fig. 4)
Model F300-6
FrAME GLUING SYSTEM
L2354 1-17
PICTURE FRAMING
Instruction Sheet
Logan Graphic Products Inc. 1100 Brown Street, Wauconda, IL 60084 1-847-526-5515 1-800-331-6232
www.logangraphic.com
Fig. 2
Fig. 4
Fig. 3
Instant Glue Gel
WARNING
Causes skin irritation. Causes serious eye irritation. May
cause respiratory irritation. Wear protective gloves & clothing/
eye protection/face protection.
FIRST AID: IF ON SKIN: Wash with plenty of soap and water.
NEVER use solvents or thinners.
IF IN EYES: Rinse eyes with cool water for several minutes.
Remove contact lenses, if present and easy to do. Continue
rinsing. If eye or skin irritation persists: Get medical advice/
attention.
IF INHALED: Remove victim to fresh air and keep at rest.
IF INGESTED: Seek immediate medical attention. NEVER
induce vomiting.
BONDS SKIN AND EYES IN SECONDS. KEEP OUT OF REACH
OF CHILDREN!
Dispose of contents and container in accordance with local
regulations.
Fig. 1
TURBO SET I
DANGER
Flammable liquid and vapor.
May be fatal if swallowed and enters airways.
Keep away from heat/sparks/open flames/hot surfaces. -- No
smoking. Ground/bond container and receiving equipment.
Use explosion-proof electrical, ventilating, and lighting
equipment. Use only non-sparking tools. Take precautionary
measures against static discharge.
Wear protective gloves and eye/face protection.
FIRST AID: IF SWALLOWED: Immediately call a POISON
CENTER or doctor/physician. Do NOT induce vomiting. IF
ON SKIN (or hair): Take off immediately all contaminated
clothing. Rinse skin with water/shower.
In case of fire: Use water fog, foam, dry chemical or carbon
dioxide (CO2) to extinguish. Keep container tightly closed
and store locked-up in a cool, well-ventilated place.
Dispose of contents and container in accordance with local
regulations.
☞
☞
HELPFUL
HINT
HELPFUL
HINT
Add a Vnail to corners to provide
additional joint security on larger
frames.
Place small sheet of paper under plate in
case of glue drops.
plate
☞HELPFUL
HINT
See YouTube video for moe details:
www.youtube.com/logangraphic
/