Fidelio DCW8010/10 Quick start guide

Brand
Fidelio
Model
DCW8010/10
Type
Quick start guide
PROG/
CLOCK
PROG/
CLOCK
Quick start guide
USB
3 sec
CD
USB
MP3
-
LINK
DCW8010
Always there to help you
Register your product for further support at
www.philips.com/welcome
Quick start guide
Option 1: Use iOS 5 Wi-Fi network login sharing (recommended)
Option 2: Set up through webpage configuration
Wait up to 30 seconds until “Philips DCW8010
XXXXXX” is detected. Then, tap it.
Disable the 3G network.
Dock your iPod touch/iPhone/iPad
onto the system.
Wait<30sec
Enter the IP address 192.168.1.1.
5.X
4.3
Check your iOS version
AirPlay
X.X.X
SettingsGeneralNetwork
SettingsGeneral About
192.168.1.1
Remember to turn on
the 3G network after
successful AirPlay
connection.
Check your router is selected.
Select this system.
Tap to play music.
Your Wi-Fi Network
If your router has a WPS button, you can connect the
device to the router through WPS.
a
Press WIFI SETUP, then the light blinks green and
yellow alternately.
b
Press the WPS button on your home Wi-Fi router.
c
Wait up to 2 minutes until the light stops blinking and
you hear a confirmation tone.
Open Settings.
Open Settings.
Wait up to 1 minute until the light
stops flashing and you hear a
confirmation tone.
If the AirPlay icon does not appear or there is no sound output, try the following ways:
a
Turn on and off the Airplane Mode in Settings.
b
Restart your iPhone.
c
It is recommended to restart your home router.
Tap AirPlay icon .
Open iPod application.
Follow the on-screen instructions to
configure the Wi-Fi settings for this system.
a
If it takes more than 2
minutes to see the screen of
step 8, try to turn on/off the
Airplane mode (Settings ->
Airplane Mode) and start
from step 2 again.
b
If the problem remains,
restart your iPhone and start
from step 2 again.
Tap ALLOW (allow) to share your
Wi-Fi settings with this system.
Tap Wi-Fi.
Open Safari.
Wait for 35 seconds until the light in the middle
of the WIFI SETUP button turns to solid yellow.
WiFi SETUP
Connect your iPod
touch/iPhone/iPad to your
home router by Wi-Fi.
Your Wi-Fi Network
WiFi SETUP
Wait 35sec
Wait for 35 seconds until the light in the middle
of the WIFI SETUP button turns to solid yellow.
WiFi SETUP
Wait 35sec
Wait< 1min
Wait up to 2 minutes until the
light stops flashing and you hear
a confirmation tone.
Wait< 2min
Philips DCW8010 XXXXXX
Philips DCW8010 XXXXXX
a
If the light does not turn solid green after 2
minutes, reconnect the power adaptor, and then
repeat steps from beginning.
b
To change Wi-Fi setup after first-time setup,
press and hold
WIFI SETUP
for more than 3
seconds to reset Wi-Fi settings. Then follow the
previous steps to change your network settings.
wireless music system with
AirPlay
PROG/
CLOCK
e subject to change without notice
©2012 Koninklijke Philips Electronics N.V.
All rights reserved.
DCW8010_10_QSG_V1.2
Before using your product, read all accompanying safety information.
Lesen Sie vor der ersten Verwendung Ihres Produktes alle beiliegenden Sicherheitsinformationen.
Antes de usar el producto, lee toda la información adjunta a la de seguridad
Veuillez lire toutes les consignes de sécurité fournies avec votre produit avant de l’utiliser.
Upgrade your iPod touch, iPhone, or iPad to iOS
4.3 or above.
Note: Make sure that Wi-Fi is enabled on your
iPod touch, iPhone, or iPad.
Before setup, you are recommended to upgrade your
iPod touch/iPhone/iPad to the latest iOS version. For
iPhone 4S users, please upgrade to iOS 5.1 or above for
optimal performance.
Page is loading ...
  • Page 1 1
  • Page 2 2

Fidelio DCW8010/10 Quick start guide

Brand
Fidelio
Model
DCW8010/10
Type
Quick start guide
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

in other languages

Related papers

Other documents