ACTi VMGB-400 VMGB-405 Installation guide

Type
Installation guide
VMGB-400
VMGB-405
Installation Guide
2019/10/02
www.acti.com
Installation Guide
2
Thank you for purchasing ACTi products and solutions. The following documentation covers
basic installation instructions of your device.
NOTE: The accuracy of the analytics algorithm may be affected by different environmental
factors or inappropriate installation. Please follow the procedures in this guide. ACTi will
not be liable for inaccuracies resulting from the aforesaid causes.
Camera Model Selection
The recognition distance between the camera and the target varies based on the camera focal
length. You should select the proper focal lens in order to get enough pixels in the frame.
The table below is for your reference:
Camera Model
Lens Focal Length
(mm)
Min recognition
distance (m)
Max recognition
distance (m)
VMGB-400
2.8-12
2.5
12
VMGB-405
8-32
7.2
28.9
Camera Installation
In order to get the best accuracy, please follow the guidelines below when installing your device.
1. It is recommended to use one device to cover one lane.
2. It’s recommended that the height of a license plate should be at least 20 to 30 pixels.
www.acti.com
Installation Guide
3
Camera Installation Height
Take note of the recommended installation height (H) and its corresponding detection distance
(L). The detection distance can be calculated as: L = tan 30 x H
Camera Installation Angle
To obtain the best license plate recognition accuracy, install your device with a proper angle to get
a clear image.
Min L(m)
4
4
5.1
6
6.8
L
H
www.acti.com
Installation Guide
4
License Plate Tilt Angle
The license plate should be as horizontal as possible. If a slight tilt cannot be avoided, be sure to
limit it within +/- 5 degrees.
Example of License Plate Tilt Angle
In addition, place the VMGB-400 in the detection area where the vehicles will go as straight as
possible, without turning left or right.
Copyright © 2019, ACTi Corporation All Rights Reserved
7F, No. 1, Alley 20, Lane 407, Sec. 2, Ti-Ding Blvd., Neihu District, Taipei, Taiwan 114, R.O.C.
TEL : +886-2-2656-2588 FAX : +886-2-2656-2599
Email: sales@acti.com
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5

ACTi VMGB-400 VMGB-405 Installation guide

Type
Installation guide

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI