AMX RDA-PSM User manual

Brand: AMX

Model: RDA-PSM

Type: User manual

AMX RDA-PSM is a 30 W module providing an un-regulated output of 12 VDC at 2.5 Amps. The power supply module is designed for use with the RDA series of Radia enclosures. The RDA-PSM is used to supply extra power to Radia control cards when the amount of power required to drive the modules exceeds the 300 mA supply on each controller.

Installation Sheet

RDA-PSM 12 VDC 2.5 Amp Power Supply Module

The RDA-PSM Power Supply is a 30 W module providing an un-regulated

output of 12 VDC at 2.5 Amps. The power supply module is designed for

use with the RDA series of Radia enclosures. The RDA-PSM is used to

supply extra power to Radia control cards when the amount of power

required to drive the modules exceeds the 300 mA supply on each

controller. The module's voltage and current ratings are CE, UL, and C-UL

approved.

RDA-PSM UL and C-UL Ratings

• Output: 12 VDC @ 2.5 A output

• Input: 120 VAC

Specifications

• Dimensions (HW): 10.00" x 2.75" (25.40 cm x 6.99 cm)

• Non-phase dependant

• Use wires rated at 75°C (167°F)

• Torque terminals to 16 in-lbs. (1.84 N/M)

• Max. wire size: 10 AWG (4 mm²)

• Wire stripping length: 0.35" (9 mm)

• Fuse rating: GMA 1 A

• Weight: 2.0 lbs. (0.91 kg)

• BTU/hr: 17

• Provides 2500 mA to drive RDM modules

• Dual 2-pin connectors provided

Caution: Pre-Installation Notes

• All Class 1 wiring must be connected to proper terminals.

• Disconnect power while installing or connecting the unit.

• Keep top and bottom air vents clear at all times.

• Test loads for shorts before connecting.

• Use low-voltage wires with a 300 volt rating or greater.

• Use field installed copper conductors.

• All electrical ratings are for continuous duty.

• For indoor use only.

FIG. 1

RDA-PSM

Tra nsfo r mer

Line in (hot)

Neutral

High-voltage

connections

Mounting

points

External +12 V

power connector (optional)

AMX Corporation reserves the right to alter specifications without notice at any time.

For full warranty information, refer to the AMX Instruction Manual(s) associated with your Product(s).

The AMX logo is a trademark of AMX Corporation. AMX reserves the right to alter specifications without notice at any time.

3000 research drive, richardson, TX 75082 USA • 469.624.8000 • 800.222.0193 • fax 469.624.7153 • technical support 800.932.6993

Lighting Application Drawing

FIG. 2 RDA-PSM, 12 VDC 2.5 Amp Power Supply Module (Method A)

Method A

Each dimmed circuit should have

a seperate neutral

AMX RDA-PSM User manual

AMX RDA-PSM User manual

Related papers