Chrysler 2017 Truck Pacifica V6-3.6L Installation guide

8/5/23, 12:49 AM

Air Outlet - Removal and Installation (Front) (Air Register) - ALLDATA Repair

https://my.alldata.com/repair/#/repair/article/56372/component/2998/itype/401/nonstandard/11250/selfRefLink/false

1/2

2017 Chrysler Truck Pacifica V6-3.6L

Vehicle > Heating and Air Conditioning > Air Register > Service and Repair > Removal and Replacement

AIR OUTLET - REMOVAL AND INSTALLATION (FRONT)

FRONT OUTER SAIR OUTLET

REMOVAL

WARNING:Disable the airbag system before attempting any steering wheel, steering column or instrument

panel component diagnosis or service. Disconnect and isolate the negative battery (ground)

cable and wait two minutes for the airbag system capacitor to discharge before performing

further diagnosis or service. This is the only sure way to disable the airbag system. Failure to

follow these instructions may result in accidental airbag deployment and possible serious or

fatal injury.

NOTE:

Right side air outlet shown. Left side air outlet similar.

1. Using a trim stick or equivalent, release the retaining

tabs (2) securing the air outlet (1) to the instrument

panel.

2. After the retaining tabs have been released, gently

pull the air outlet out of the instrument panel.

INSTALLATION

NOTE:

Right side air outlet shown. Left side air outlet similar.

1. Position the air outlet (1) to the opening in the instrument panel and align the outlet to the instrument

panel

duct

2. Engage the retaining tabs (2) that secure each air outlet to the instrument panel. Make sure the retaining

tabs are fully engaged.

8/5/23, 12:49 AM

Air Outlet - Removal and Installation (Front) (Air Register) - ALLDATA Repair

https://my.alldata.com/repair/#/repair/article/56372/component/2998/itype/401/nonstandard/11250/selfRefLink/false

2/2