2. Tern
  3. DuoStand
DuoStand

Tern DuoStand Operating instructions

  • Hello! I've reviewed the user manual for the Tern DuoStand kickstand, designed for HSD Gen 1 and 1A bikes. The document covers safety precautions, included components, required tools, and step-by-step installation guidance for different frame variants. I'm here to help with any questions about the product.
  • What is the maximum load limit for the DuoStand?
    What tools are required for installation?
    What bikes are compatible with the DuoStand?
11
ternbicycles.com
DuoStand™
Safety
Do not exceed the load limit of 60 kg (132 lb). Please remember
the max load limit includes the weight of the bike.
Never leave children on a parked bike unattended.
Compatible Bikes
• HSD Gen 1
• HSD Gen 1A
What’s Included
• DuoStand
• Wing-shaped Plate
• Bolt Set x 2
Installation
Tools required (not included)
• 17 mm Wrench x 2
• 5 mm Allen Wrench
1. Remove the existing kickstand. 2. Identify the HSD frame variant by locating the
kickstand mount in front of the rear wheel.
HSD Gen 1 HSD Gen 1A
Mounting Location
HSD Gen 1 only
HSD Gen 1 frame variants
WARNING: Route cables as shown to avoid damage from compression.
22
ternbicycles.com
DuoStand™
LIMITED PRODUCT WARRANTY INFORMATION: This Product comes with a ONE (1) YEAR Limited Warranty from the date of retail purchase by the
original end-user. If a material or workmanship defect arises and a valid claim is received within the Warranty Period, this Product will be replaced.
Mobility Holdings cannot be held liable for damages to personal property due to misuse or improper care and maintenance. This Product Warranty
does not, under any circumstance, cover the replacement or cost of any third party product used with or connected to the Product.
Tern, the Tern Werd (logotype), the Tern Berd (device), and DuoStand used alone or in combination are trade names, trade devices or registered
trademarks of Mobility Holdings, Ltd.
© 2021. Tern is a trademark of Mobility Holdings, Ltd. All Rights Reserved.
ternbicycles.com
17 mm
17 mm
17 mm
17 mm
4. Tighten Bolts to a torque of 35-40 Nm.
3. Install hardware in the order shown.
HSD Gen 1
HSD Gen 1
HSD Gen 1A
HSD Gen 1A
@ternbicycles
Assembly Order
1. Nut
2. Washer
3. Wing-shaped plate*
4. Bushing*
5. HSD
6. DuoStand
7. Washer
8. Bolt
Assembly Order
1. Nut
2. Washer
3. HSD
4. DuoStand
5. Washer
6. Bolt
* Wing-shaped
plate and Bushing
are needed
for installing
DuoStand on
HSD Gen 1 only.
/