2. Kuzco Lighting
  3. VL63416
VL63416

Kuzco Lighting VL63416 Installation guide

  • Hello! I've reviewed the installation sheet for the Kuzco VL63416 LED Vanity Light. This document provides instructions for installing the fixture using both an octagon junction box and a single gang box. It also notes the use of pre-wired LED modules and compatibility with ELV dimmers. I'm ready to answer any questions you have about the installation process or specifications.
  • What type of dimmer is required for this LED fixture?
    Is it safe to touch the LED module?
    What is the input voltage for this fixture?
INSTALLATION SHEET
VL63416
START FROM HERE
•
Make sure power is completely off at the fuse box.
•
Have your fixture installed by a qualified licensed electrician
•
Prepare everything in a clear area.
•
Wear gloves at all times during this installation.
•
Read instructions carefully before you start assembly.
•
Keep this instruction sheet for future reference.
Technical Support: 1-855-855-8926
LED Vanity Light
19054 28th Avenue Surrey, BC Canada V3Z 6M3
T: 604 538 7162 TF: 1-855 85 KUZCO F: 604 538 7196
W: kuzcolighting.com
1a.1b.1c.1d.1f.1g.1h.2a.2b.
1.
2.
3.
4.
1.
2.
3.
4.
(Octagon junction box install) (Single gang box install)
1a.1b.1g.1d.2a.2b.
1e.
20210401
Remove the fixture from its original packaging. Next,
remove the mounting plate (1g) from the fixture (2a) by
removing fixture screws (2b)
Secure the universal mounting plate (1c) to the electrical
junction box (1a) with junction box screws (1d) provided
in the hardware package. Secure backplate (1f) to
mounting plate (1g) with screws (1e). Attach backplate
(1f) and mounting plate (1g) assembly to universal
mounting plate (1c) with screws (1h)
Make proper electrical connections (black to hot “L”,
white to neutral “N”, ground to “GND”) with wire nuts
(1b) provided in hardware package
Attach the fixture (2a) to mounting plate (1g) and secure
with fixture screws (2b)
Remove the fixture from its original packaging. Next,
remove the mounting plate (1g) from the fixture (2a) by
removing fixture screws (2b)
Secure the mounting plate (1g) to the electrical junction
box (1a) with junction box screws (1d) provided in the
hardware package
Make proper electrical connections (black to hot “L”,
white to neutral “N”, ground to “GND”) with wire nuts
(1b) provided in hardware package
Attach the fixture (2a) to the mounting plate (1g) and
secure with fixture screws (2b)
Please Note:
• This Kuzco LED fixture comes with pre-wired LED module(s)
• Unless instructed, Do Not touch any part of the LED module(s) as any unnecessary
contact with the module could cause permanent damage
• For dimming, an ELV (Electronic Low Voltage) type of dimmer is required
• 120V input
/