KUZCO EW25707 Installation guide

Brand: KUZCO

Model: EW25707

Type: Installation guide

Below you will find brief information for EW25707. This document provides guidance on how to install the Kuzco LED Exterior Wall Sconce model EW25707. It advises to ensure power is off, use a qualified electrician, wear gloves, and read instructions before starting. It also specifies the need for an ELV or TRIAC dimmer. The instructions detail the steps to mount the fixture, make electrical connections, and seal against moisture.

Below you will find brief information for EW25707. This document provides guidance on how to install the Kuzco LED Exterior Wall Sconce model EW25707. It advises to ensure power is off, use a qualified electrician, wear gloves, and read instructions before starting. It also specifies the need for an ELV or TRIAC dimmer. The instructions detail the steps to mount the fixture, make electrical connections, and seal against moisture.

INSTALLATION SHEET

EW25707

LED Exterior Wall Sconce

START FROM HERE

19054 28th Avenue Surrey, BC Canada V3Z 6M3

T: 604 538 7162 TF: 1-855 85 KUZCO F: 604 538 7196

W: kuzcolighting.com

20210309

• Make sure POWER is COMPLETELY OFF at the fuse box

• Have your fixture installed by a qualified licensed electrician

• Prepare everything in a clear area

• Wear gloves at all times during this installation

• Read instructions carefully before you start assembly

• Keep this installation sheet for future reference

Technical Support: 1-855-855-8926

Please Note:

• This Kuzco LED fixture comes with pre-wired LED module(s)

• Unless instructed, Do Not touch any part of the LED module(s) as any unnecessary

contact with the module could cause permanent damage

• For dimming, an ELV (Electronic Low Voltage) or TRIAC type of dimmer is required

• 120V input

7. To prevent moisture from entering the electrical junction

box (1a) and causing a short, seal around the top and side

perimeter between the fixture and the wall surface with

weather resistant caulking (Illustration 1). The space at

the bottom should be left un-caulked to prevent moisture

build up

1.

2.

3.

4.

5.

6.

Remove fixture from its original packaging

Separate the mounting plate (1c) from the canopy (2a) by

removing the set screws (2f) with allen key

Attach mounting plate (1c) to electrical junction box (1a)

using junction box screws provided (1e) in hardware package

Make proper electrical connections (black to hot “L”,

white to neutral “N”, ground to “GND”) with wire nuts (1b)

provided in hardware package and insert driver (4a) into

mounting plate (1c)

Secure canopy (2a) to mounting plate (1c) with set screws

(2f) and allen key

Rotate fixture head (3a) into desired position

Illustration 1

Caulking

4a. 1c.1e. 1b. 1a.

3a.

2a. 2f.

1

KUZCO EW25707 Installation guide

Brand: KUZCO

Model: EW25707

Type: Installation guide

Below you will find brief information for EW25707. This document provides guidance on how to install the Kuzco LED Exterior Wall Sconce model EW25707. It advises to ensure power is off, use a qualified electrician, wear gloves, and read instructions before starting. It also specifies the need for an ELV or TRIAC dimmer. The instructions detail the steps to mount the fixture, make electrical connections, and seal against moisture.

Download PDF

Related papers

Other documents