AHD 1080P Backup Camera System Operating instructions

I. Function keys

2.Key introductions

1) AHD channel switch button

2) Compound confirmation key

a. Short press confirm menu function,

picture mode video cameras, video

mode began to stop function, the

playback mode playback function;

b.Long press to switch video, photo,

playback modes;

3) Menu button

4) Reduce, key menu page up button;

5)Plus, menu page down keys

6) Power key

3. The remote control function

1 . POWER : Switch for power supply

2 . VIDEO : V1 / 2 selecting

3 . VOL +: Increase button / select channel

4 . MENU : ( brightness , colors , contrast ) button

5 . MODE : Selecting results of display

6 . VOL - : Reduces button / select channel

4. Function parameters

Screen dimensions : 7 inch

Resolution : 1024 ( W ) X RGB X 60（H）

Brightness : 500 cd/m2

Screen Angle : the Angle of view ( IPS )

System : PAL/NTSC

Power : DC 12V-35V

Consumption : 6W

Video : two way video input

1.connect black line to the 12v-14v negative power -

2.connect red line to the 12V-14V ACC.

3.connect yellow line to the 12V-14V positive power +

4.connect green line to the positive of the reverse light +

Note:If you connect blue cable,when you put rear gear,the screen will automatically switch to V2

image. If you do not need this function,you leave blue cable disconnected,and covered by

insulating tape.