Page is loading ...
IF YOU HAVE ANY QUESTIONS OR PROBLEMS,
CALL THIS TOLL FREE HELP LINE.
STOP!
DO NOT ASSEMBLE YOUR PIANO
BEFORE READING THIS GUIDE!
1
•
8OO
•
854
•
1594
Easy
Assembly
Guide
The Name You Know
Suzuki Home Digital Piano
ATTENTION!
Use these instructions for Piano Assembly.
D1 D3
D2 D4
1. Un p a c k i n g Yo U r ne w Digital pi a n o
2. pi a n o as s em b l Y
A. Placing the Pedal Cable
Take off the cable slot cover in the side board.
Lay in the pedal cable from the pedal cross bar
then insert the cover.
B. Pedal Crosspiece Installation
Attach the Pedal Crosspiece to the leg with the
M6X20 Screw.
D. Hardware enclosed:
D1. Ten M6x20 Screws
D2. Four M6x15 Screws
D3. Two 4x12
Self-tapping Screws
D4. Six 4x16
Self-tapping Screws
A. Carefully unpack the Piano components and set aside.
IMPORTANT!
Be sure to unpack the Hardware and Power Cord from the
protective foam pieces.
B. Using 2 people, lift your new Piano out of the carton
and place on a soft surface such as a carpet or blanket.
C. Remove the protective outer packing materials from the Piano.
IMPORTANT!
Use only your hands to remove the protective materials. Sharp tools
may damage the piano.
The finish of your Piano is now exposed. Take care not to let foreign
objects come into contact with the Piano.
Pedal Cable Cover
Cable Slot Cover
(Continued)
3. at t a c h i n g t h e pr i v a c Y bo a r D
A. Align the Privacy Board to the backside
of the Leg Stands.
B. Privacy Board Installation
First attach the back board to the top of the piano legs as
shown with M6x15. Then use the M4x16 Self-tapping screw to
attach the bottom.
IMPORTANT!
Do not over tighten the screws.
4. at t a c h i n g t h e pi a n o
t o t h e st a n D
5. pi a n o bo D Y in s t a l l a t i o n
A. Using two people, lift the Piano onto the Leg Stands
and Pedal Board assembly.
A. Place the piano body on the assembled stand and attach it
with the M6x20 Screw. Install the headphone holder in the proper
location with the 4x12 Self-tapping Screw. Plug the pedal connector
into the socket on the bottom.
Headphone Holder
Questions?
Call 1•800•854•1594
5. at t a c h i n g t h e pi a n o t o t h e st a n D
en j o Y Yo U r ne w sU z U k i Digital pi a n o !
© 2008 Suzuki Corporation
The Name You Know
B. Locate the Power Cord
and plug it into the Receptacle
on the bottom of the Piano.
Plug the Power Cord into an
appropriate wall socket.
C. Refer to the Owner’s
Manual for piano operation.
a. Place the piano in its final position then turn the
Pedal Brace Knob down to the firmly touch the floor.
Check and tigthen all screws at this time.
/
