QUICK START GUIDE

HPG-10 HydraPort 3/4-inch Mini Grommet

© 2015 Harman. All rights reserved. HydraPort, AMX, AV FOR AN IT WORLD, HARMAN, and their respective logos are registered trademarks of

HARMAN. Oracle, Java and any other company or brand name referenced may be trademarks/registered trademarks of their respective

companies.

AMX does not assume responsibility for errors or omissions. AMX also reserves the right to alter specifications without prior notice at any time.

Mini-Grommets are designed to be mounted into a variety of surfaces such as a

conference room table, desk, or lectern in order to manage A/V, power, and/or

networking cables.

Product Specif ications

Installation

Too l s R e q u ired

•Drill

• 3/4" Drill bit (Forstner, Auger, or Spade Bit)

• Note that the HPG-10 requires 0.2" (5mm) above the mounting surface.

2) Drill The Hole In The Mounting Surface

Some lower quality drill bits may create torn edges or a slightly larger hole, which will

cause the HPX-10 to fit loosely in the hole or expose edges of the cut. If in doubt, test

the drill bit for proper fit before drilling into the final mounting surface.

1. Carefully measure the tabletop or other mounting surface to locate the desired

position of the HPG-10.

Take care to ensure that the top surface of the mounting surface is not damaged

For cables for which the far end of the cable is not accessible, either because the cable

has been run under carpet, is in a conduit or structure, or is otherwise fixed, the cable

must be placed through the cutout in the table prior to installation (see FIG. 2).

2. Place each half of the HPG-10 Mini-Grommet on either side of the cable and press

3. Press the assembled HPG-10 Mini-Grommet into the ¾" hole (FIG. 3). The fit of