Paradyne Hotwire 7974 Wall Mounting Installation Instructions

Brand
Paradyne
Model
Hotwire 7974
Type
Wall Mounting Installation Instructions
7900-A2-GZ42-00 October 2002
1
Hotwire
®
TDM SDSL Standalone Termination Unit, Model 7974
Wall Mounting Installation Instructions
Document Number 7900-A2-GZ42-00
October 2002
Wall mounting the Hotwire 7974 TDM SHDSL Standalone Termination Unit
requires two wood screws suitable for the weight of the fully cabled unit into a
wood surface. Two sets of 1/2-inch (12.7 millimeters) screws with 0.265-inch
(6.73 millimeters) diameter heads are included. However, if you are installing the
unit on a surface other than wood (such as drywall), longer screws are required
(not provided).
The unit can be mounted as follows:
Horizontally, with the LEDs facing up
Vertically, with the LEDs facing toward the left
See the procedure on the next page to install the Model 7974 unit on a wall.
2
October 2002 7900-A2-GZ42-00
Procedure
To install the Model 7974 unit on a wall:
1. Identify the screws provided in the hardware kit. Two screws are required for
each bracket.
2. Using the template provided, mark the placement of the screw holes on the
wall (see
Model 7974 Standalone Termination Unit Hardware Template
on
page 3). The unit can be mounted either vertically or horizontally.
3. Use a screwdriver to install the screws into the wall. Do not install the screws
flush with the wall. Leave enough clearance to hang the unit housing from the
screws.
4. Hang the unit from the screws.
Wall
Fasteners
02-17342
7900-A2-GZ42-00 October 2002
3
Model 7974 Standalone Termination Unit Hardware Template
02-17338
5.00
3.75
4
October 2002 7900-A2-GZ42-00
Document Feedback
We welcome your comments and suggestions about this document. Please mail
them to Technical Publications, Paradyne Corporation, 8545 126th Ave. N., Largo,
FL 33773, or send e-mail to
userdoc@paradyne.com
. Include the number and
title of this document in your correspondence. Please include your name and
phone number if you are willing to provide additional information.
Trademarks
Hotwire is a registered trademark of Paradyne Corporation. All other products and
services mentioned herein are the trademarks, service marks, registered
trademarks, or registered service marks of their respective owners.
*7900-A2-GZ42-00*
Copyright
©
2002 Paradyne Corporation. Printed in U.S.A.
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4

Paradyne Hotwire 7974 Wall Mounting Installation Instructions

Brand
Paradyne
Model
Hotwire 7974
Type
Wall Mounting Installation Instructions
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents