Polycom WebCam Setting Up

Polycom
Brand
Polycom
Model
WebCam
Category
Camera mounting accessories
Type
Setting Up
What's in the boxes? Setting up the Controller
Note: If you are connecting an optional Polycom® VSX™ video conferencing system to your Polycom PowerCam Presenter™, see the other side of this document.
Setting up the Polycom PowerCam Presenter
IOIOIO
90-250VAC 50/60Hz 4A
LAN
1
1
2
21
VCR/DVD
Presenter icons and
Video output from
connector shows
messages
Setting up the Locator Pack Assembly
VCR or DVD recorder
Display
Any video conferencing system
Display
Tight
Wide Off
Left
Right
Presenter View
Select
Menu
Zoom In
Zoom Out
Auto Zoom
Preset 1
Preset 2
Charging time: 3 hours
Operating time: 8 hours
4
3
2
1
software
Use only for
upgrading
Attach the belt clip to the locator pack OR attach the lanyard to the locator pack.
Refer to the User’s Guide for the Polycom PowerCam Presenter for important
information about charging and using the battery pack.
Caution
8’ S-video cable 25’ S-video cable
Camera power cables
Male RCA to female
S-video adapter
10’ or 100’ camera cable
LAN cable
A/C power cable
b
©2006, Polycom, Inc. All rights reserved. Polycom® and the Polycom logo are registered trademarks, and Polycom PowerCam Presenter™ and VSX™ are trademarks of Polycom, Inc.
1725-23626-001/A
Setting up the Controller with a VSX Video Conferencing System
IOIOIO
90-250VAC 50/60Hz 4A
LAN
1
1
2
21
Powering on the Polycom PowerCam Presenter
3
2
1
4
Setting up the Camera
Leave at least 1 foot (.3 meters) between the
back of the camera and the wall. If you add
acoustic foam on the wall, you can place the
camera slightly closer than 1 foot (.3 meters)
from the wall.
Place the camera where it will be no more than
50 feet (15.2 meters) away from the person
wearing the locator.
Place the camera about 6 feet (1.8 meters) to
7 feet (2.1 meters) above the floor.
VSX video conferencing system
PowerCam Presenter Controller
software
Use only for
upgrading
VCR/DVD
IR
3
1
2
VGA
IOIOIO
PC CARD
90-250VAC 50/60Hz 4A
LAN
1
2
1
VGA
2
1
2
3
After all the cables are connected, power on the Polycom
PowerCam Presenter controller:
If you have a VSX video conferencing system, power it on next:
Wait 90 seconds, and then power on the locator pack:
Presenter icons and
Video output from
connector shows
messages
Display
8’ S-video cable
LAN cable
A/C power cable
10’ or 100’ camera cable
10’ or 100’ camera cable
Camera
adapter
cable
25’ S-video cable
S-video gender
changer adapter
Male RCA to
female S-video
adapter
Camera power cables
  • Page 1 1
  • Page 2 2

Polycom WebCam Setting Up

Polycom
Brand
Polycom
Model
WebCam
Category
Camera mounting accessories
Type
Setting Up
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents