D&B Z2501/02/03 E-PAC Rack mount kit Mounting instructions
- Category
- Rack accessories
- Type
- Mounting instructions
This manual is also suitable for
Z2501/Z2502/Z2503
E-PAC Rack mount kit
Mounting instructions
WARNING!
IMPORTANT!
CAUTION!
General Information
Mounting instructions
Z2501/Z2502/Z2503 E-PAC Rack mount kit
Version 4.0E, 04/2001, D0020007
Copyright d&b audiotechnik AG 2001; all rights reserved.
The information presented in this document is, to the best of our
knowledge, correct. We will however not be held responsible for
the consequences of any errors or omissions. Technical
specifications, weights and dimensions can change and should
always be confirmed with d&b audiotechnik AG prior to inclusion
in any additional documentation.
d&b audiotechnik AG
Eugen-Adolff-Strasse 134, D-71522 Backnang
Telephone +49-7191-9669-0, Fax +49-7191-95 00 00
Z2501/Z2502/Z2503 E-PAC Rack mount kit
References in the manual
This refers to a potentially danger-
ous situation which may lead to
personal injury.
This refers to a potentially danger-
ous situation which may lead to
equipment damage.
This refers to a situation which may
cause the equipment to malfuncti-
on.
Symbols on the equipment
Please refer to the information in
the operating manual.
Rack mount kit parts
IMPORTANT!
(4.0E) Z2501/Z2502/Z2503
E-PACs with solo/dual rack mount kits
Z2501/Z2502/Z2503 E-PAC Rack mount kit
A single E-PAC may be installed in a standard 19" or 9.5" equipment
rack or flightcase. Further a single E-PAC or a pair side-by-side may be
installed in a standard 19" equipment rack or flightcase. E-PACs require
two rack units and, including connectors, a minimum rack depth of
40 cm (15.7 "), mounting ear to rack rear panel.
Safety instruction
It is recommended that additional support
be provided within the rack by using the rear
mounted rack ears. This is particularly im-
portant if E-PACs are being racked for road
use.
The E-PAC enclosure can get hot during
operation, therefore allow a gap of at
least 2 cm (3/4") between an E-PAC and
the rack top/bottom panels, or other
equipment above or below. This is not
necessary between adjacent E-PACs.
When installing E-PACs always allow suffi-
cient free air flow around the enclosure
and never block or cover the rear panel air
intake vent or the front panel air outlet vent.
If E-PACs are to be installed in sealed equip-
ment racks, then additional fan modules will
be needed. The E-PAC air intake is at its rear
panel; therefore external fans should supply
air to the inside of the rack.
The solo rack mount kit (Z2501) includes the following parts:
1 front blanking panel [5]
1 front rack mounting bracket [2]
1 rear mounted rack ear [3]
4 mounting rails [1]
6 Allen screws [S], Allen key
The dual rack mount kit (Z2502) includes the following parts:
2 front rack mounting brackets [2]
2 rear mounted rack ears [3]
2 connector brackets [4]
8 mounting rails [1]
16 Allen screws [S], Allen key
The solo rack mount kit (Z2503) includes the following parts:
2 front rack mounting brackets [2]
2 rear mounted rack ears [3]
4 mounting rails [1]
8 Allen screws [S], Allen key
d&b audiotechnik AG, Eugen-Adolff-Str. 134, D-71522 Backnang, Germany, Phone +49-7191-9669-0, Fax +49-7191-95 00 00
Attachment of brackets and rack ears
1
2
S
483 [19.00"]
465 [18.30"]
76 [3.00"]
E-PAC E-PAC
190 [7.48"]
336 [13.23"]
88 [3.46"]
E-PAC
88 [3.46"]
338 [13.31"]
357 [14.06"]240 [9.45"]
222 [8.74"]
76 [3.00"]
E-PAC
E-PAC enclosure dimensions with rack mount kits in mm [inch]
Mounting
The solo rack mount kit (Z2501) allows one E-PAC to be mounted either
to the left or the right hand side in a standard 19" equipment rack or
flightcase.
The dual rack mount kit (Z2502) allows two EPACs side-by-side to be
mounted in a standard 19" rack or flightcase.
The solo rack mount kit (Z2503) allows one E-PAC to be mounted in a
9.5" equipment rack or flightcase.
The mounting rails [1] are inserted into channels located in the side
walls of the E-PAC aluminum enclosure. The different fittings
[2,3,4 and 5] are attached using countersunk Allen (Hex) screws [S].
-
1
-
2
-
3
-
4
D&B Z2501/02/03 E-PAC Rack mount kit Mounting instructions
- Category
- Rack accessories
- Type
- Mounting instructions
- This manual is also suitable for
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI