Atdec AC-AP-UTH Installation guide

Brand: Atdec

Model: AC-AP-UTH

Type: Installation guide

Installation Instructions

Universal Tablet Holder

Step 1. Check components

Component Checklist

Hardware

IMPORTANT INFORMATION

Step 2. Attach tablet holder to VESA mount

Systema Visidec Focus Spacedec/Telehook

Step 3. Attach tablet to tablet holder

OR OR

AC-AP-UTH

! IMPORTANT - Install as per Installation Instructions

! This product is used to mount tablet devices only.

! This product is compatible with Atdec’s Systema, Visidec and

Spacedec range of monitor mounts. Also compatible with

100x100 VESA mounting plates.

! The maximum thickness of the supported tablet is 15mm (0.6”).

! The minimum width of the supported tablet is 140mm (5.5”).

! The maximum height of the supported tablet is 255mm (10”).

! Ensure your tablet is mounted centrally on the Universal Tablet

Holder for optimum stability.

! Ensure holder tabs do not interfere with buttons on your tablet.

! The manufacturer accepts no responsibility for incorrect

installation.

Check that you have received all parts against the Component Checklist.

Tablet can be mounted in Landscape

or Portrait orientations.

Universal Tablet Mount

2.5mm Allen Key

M4x15 Screw (x4)

1. Pull the top tab up

2. Position bottom

edge of tablet into

lower tabs

3. Push tablet ﬂat

against the back

of the mount.

Allow the top tab

to retract over the

edge of the tablet.

No portion of this document or any artwork contained herein should be reproduced in any way without the express written consent of Atdec Pty Ltd.

Due to the continuing product development, the manufacturer reserves the right to alter speciﬁcations without notice. Published 10/11/15 ©

Atdec AC-AP-UTH Installation guide

Atdec AC-AP-UTH Installation guide

Atdec AC-AP-UTH Installation guide

Related papers

Other documents