Paradyne Hotwire 7915-A1 User manual

7915-A2-GK41-00

March 1998

Hotwire 7915-A1 E1 SDSL Standalone Termination Unit

Errata

Document Number 7915-A2-GK41-00

March 1998

Errors and exclusions in the

Hotwire Model 7915 Standalone E1 SDSL Termination Unit User’s Guide

(Document No. 7915-A2-GB20-20) were detected after printing. Please make note of the following

correction.

The following information should be included on page B-3:

E1 Network 120 Ohm Connection Cable

Pin Assignments

The 120 ohm modular connector that plugs into the rear panel of

G.703-compatible units has the following pin assignments.

Signal

1 Tx Ring

2 Tx Tip

3 unused

4 Rx Ring

5 Rx Tip

6 – 8 unused

NOTE:

Pin 1 is on the left when viewing the jack from its inserted position.



*7915–A2–GK41–00*

This manual is also suitable for