Electrolux EFG5530X User manual

Brand: Electrolux

Model: EFG5530X

Category: Cooker hoods

Type: User manual

This manual is also suitable for

Electrolux EFG5530X is a kitchen hood designed to eliminate cooking odors. It can be used in two modes: the air is either recirculated and cleaned through the charcoal filter, or it is exhausted outside through a pipe. The hood has three speed settings, allowing you to adjust its power to the amount of smoke and odors produced during cooking. It is equipped with two metal grease filters that can be easily removed and cleaned in a dishwasher. The hood also has two LED lights that illuminate the cooking area.

Page is loading ...

We were thinking of you

when we made this product

electrolux 3

EMPFEHLUNGEN UND HINWEISE 6

CHARAKTERISTIKEN 7

MONTAGE 9

BEDIENUNG 11

WARTUNG 12

CONSEILS ET SUGGESTIONS 13

CARACTERISTIQUES TECHNIQUES 14

INSTALLATION 16

UTILISATION 18

ENTRETIEN ET NETTOYAGE 19

CONSIGLI E SUGGERIMENTI 20

CARATTERISTICHE 21

INSTALLAZIONE 23

USO 25

MANUTENZIONE 26

RECOMMENDATIONS AND SUGGESTIONS 27

CHARACTERISTICS 28

INSTALLATION 30

USE 32

MAINTENANCE 33

Page is loading ...

20 electrolux Caratteristiche

CARATTERISTICHE

Ingombro

Page is loading ...

26 electrolux Recommendations and Suggestions

Installation

• The manufacturer will not be held li-

able for any damages resulting from

incorrect or improper installation.

• The minimum safety distance be-

tween the cooker top and the extrac-

tor hood is 650 mm.

• Check that the mains voltage corre-

sponds to that indicated on the rating

plate ﬁ xed to the inside of the hood.

• For Class I appliances, check that the

domestic power supply guarantees

adequate earthing.

Connect the extractor to the exhaust

ﬂ ue through a pipe of minimum diam-

eter 120 mm. The route of the ﬂ ue

must be as short as possible.

• Do not connect the extractor hood to

exhaust ducts carrying combustion

fumes (boilers, ﬁ replaces, etc.).

• If the extractor is used in conjunction

with non-electrical appliances (e.g.

gas burning appliances), a sufﬁ cient

degree of aeration must be guaran-

teed in the room in order to prevent

the backﬂ ow of exhaust gas. The

kitchen must have an opening com-

municating directly with the open air in

order to guarantee the entry of clean

air.

Use

• The extractor hood has been de-

signed exclusively for domestic use to

eliminate kitchen smells.

• Never use the hood for purposes

other than for which it has ben de-

signed.

• Never leave high naked ﬂ ames under

the hood when it is in operation.

• Adjust the ﬂ ame intensity to direct it

onto the bottom of the pan only, mak-

ing sure that it does not engulf the

sides.

• Deep fat fryers must be continuously

monitored during use: overheated oil

can burst into ﬂ ames.

• Do not ﬂ ambè under the range hood;

risk of ﬁ re

• The hood should not be used by chil-

dren or persons not instructed in its

correct use.

Maintenance

• Switch off or unplug the appliance

from the mains supply before carrying

out any maintenance work.

• Clean and/or replace the Filters after

the speciﬁ ed time period.

• Clean the hood using a damp cloth

and a neutral liquid detergent.

The symbol on the product or on its

packaging indicates that this product may

not be treated as household waste. Instead

it shall be handed over to the applicable

collection point for the recycling of electrical

and electronic equipment. By ensuring this

product is disposed of correctly, you will help

prevent potential negative consequences for

the environment and human health, which

could otherwise be caused by inappropriate

waste handling of this product. For more

detailed information about recycling of this

product, please contact your local city ofﬁ ce,

your household waste disposal service or

the shop where you purchased the product.

RECOMMENDATIONS AND SUGGESTIONS

Characteristics electrolux 27

Dimensions

CHARACTERISTICS

28 electrolux Characteristics

Components

Ref. Q.ty Product Components

1 1 Hood Body, with: Controls, Light,

Blower, Filters

9 1 Reducer Flange ø 150-120 mm

10 a 1 Damper

10 b 1 Adapting ring ø 120-125 mm

Ref. Q.ty Installation Components

12a 8 Screws

Q.ty Documentation

1 Instruction Manual

10b

10a

12a

Installation electrolux 29

INSTALLATION

INSTALLATION ON SCREWS

• The hood can be installed either di-

rectly on the bottom surface of the

wall units (min. 650 mm above the

hob) using snap-on side supports.

• Cut a ﬁ tted opening in the bottom sur-

face of the wall unit, as shown.

• Fix using the 8 screws 12a provided.

SNAP-ON FITTING

• The hood can be installed either di-

rectly on the bottom surface of the

wall units (min. 650 mm above the

hob) using snap-on side supports.

• Cut a ﬁ tted opening in the bottom sur-

face of the wall unit, as shown.

• Insert the hood until the side supports

snap into place.

• Lock in position by tightening the

screws Vf from underneath the hood.

259

497 - 677

259

497 - 677

12a

30 electrolux Installation

Connection in Ducting Version

When installing the ducting version,

connect the hood to the chimney using

either a ﬂ exible or rigid pipe ø 150 or

125 mm, the choice of which is left to

the installer.

To install a ø 150

• To install the dumper 10a.

• Fix the pipe in position using sufﬁ cient

pipe clamps (not supplied).

To install a ø 125

• To install a ø 125 mm air exhaust con-

nection, insert the reducer ﬂ ange 9 on

the dumper 10a.

• To install the Adapting ring 10b.

• Fix the pipe in position using sufﬁ cient

pipe clamps (not supplied).

• Remove any activated charcoal ﬁ l-

ters.

Connection in Recycling Version

• Connect the ﬂ ange to the outlet on

the shelf over the hood using a ﬂ exible

or rigid pipe (ø120 or 150 mm).

• To install a ø 120 mm air exhaust con-

nection, insert the reducer ﬂ ange 9 on

the hood body outlet.

• Fix the pipe in position using sufﬁ cient

pipe clamps (not supplied).

• Ensure that the activated charcoal ﬁ l-

ters have been inserted.

Electrical Connection

• Connect the hood to the mains

through a two-pole switch having a

contact gap of at least 3 mm..

10a

ø 150

10a

10b

ø 125

ø120

Page is loading ...

32 electrolux Maintenance

MAINTENANCE

Cleaning Metal Self- Supporting

Grease Filters

• The ﬁ lters must be cleaned every 2

months of operation, or more fre-

quently for particularly heavy usage,

and can be washed in a dishwasher.

• Remove the ﬁ lters one at a time hold-

ing them up with one hand and pulling

the handle downwards with the other

hand at the same time.

• Wash the ﬁ lters, taking care not to

bend them. Allow them to dry before

reﬁ tting.

• When reﬁ tting the ﬁ lters, make sure

that the handle is visible on the out-

side.

Replacing the Charcoal Filter

• Charcoal ﬁ lter cannot be regenerated

or washed. It has to be substituted at

least every 4 months or even more

frequently when the use of the hood is

particularly intensive.

• Remove the ﬁ lter support pulling

downwards the side levers.

• Remove the saturated charcoal ﬁ lter

by releasing the ﬁ xing hooks

• Fit the new ﬁ lter and fasten it in its cor-

rect position.

• Put the metal grease ﬁ lters in their

seats.

Light replacement

40 W incandescent light.

• Remove the metal grease ﬁ lters.

• Unscrew the bulbs and replace them

with new ones having the same char-

acteristics.

• Replace the metal grease ﬁ lters.

Page is loading ...

www.electrolux.com

436004110_01 - 080401

Electrolux EFG5530X User manual

Brand: Electrolux

Model: EFG5530X

Category: Cooker hoods

Type: User manual

This manual is also suitable for

Download PDF

report

in other languages

italiano: Electrolux EFG5530X Manuale utente
français: Electrolux EFG5530X Manuel utilisateur
Deutsch: Electrolux EFG5530X Benutzerhandbuch

Electrolux EFG5530X User manual

This manual is also suitable for

Electrolux EFG5530X User manual

in other languages

Related papers

Other documents