Öhlins Front Fork Kit for Husqvarna TE 450
FGHA 1084
Application Specific Mounting Instructions
Issued 2010-03-22
Kit Contents (application specific)
Recommended Tools (application specific)
Hydraulic Stop Cup
Set-Up Data
Spring Recommendation
Part No. Pcs.
Front Fork kit FGHA 1084 1
Base plug (with o-rings) 15430-08 2
Spacer 2 mm 15443-02 8
Hydraulic Stop Cup 15456-05 2
Spring Support washer 15450-02 2
OEM Fork Cap tool, Socket 19 mm
ALLEN KEY for OEM Base Plug 14 mm
Socket for Öhlins Base Plug 22 mm
FGHA 1084 Cartridge kit comes with a Öhlins Hydraulic stop
cup and a spring support washer. Stop cup shall be installed
according to step 10 and support washer according to step 12
in the “Owners manual and general mounting instructions”.
Rebound Damping 10 clicks
Compression Damping 15 clicks
Spring Preload 0 mm
Fluid Volume (each leg) 0,340 litre
Cartridge Kit FGHA 1084 shall be used together with
Öhlins Front Fork Springs part no. 08763-xx. For rate
recommendations, see Owner’s Manual/ General Mounting
Instructions.
Note!
The fork springs need to be ordered separately depending on the
rider’s choice of spring rate.
Part No. Pcs.
Circlip 15440-01 2
Öhlins Sticker 00197-01 2
TTX Cartridge Sticker 00191-29 2
Spring preload range -2 to 8 mm
(can be adjusted by adding/removing washers 15443-02)
Fluid volume range (each leg) 0,300 - 0,400 litre
Öhlins Front Fork uid 01312-01
/