Fishbone Offroad FB21120 Installation guide

Brand
Fishbone Offroad
Model
FB21120
Type
Installation guide
FB21120
Jeep® ’18-Current JL Wrangler & ’20 JT Gladiator
Headlight Guards
REQUIRED TOOLS
Body Clip Remover
10mm Socket
4mm Allen
KIT CONTAINS
Headlight Guard (Left)
Headlight Guard (Right)
Button Head Bolt
QTY
1
1
6
FB21120
Jeep® ’18-Current JL Wrangler & ’20 JT Gladiator
Headlight Guards
1
1) REMOVE YOUR GRILL
Open your vehicle’s hood.
With a body clip remover, remove the 6 body clips
located just above the grill. ………………………….
Remove the grill by gently and evenly pulling at its
bottom, releasing the 6 white retaining clips.
2) REMOVE HEADLIGHT HARDWARE
With a 10mm socket, remove the 3 bolts securing
your headlights to the vehicle. ……………………….
3) INSTALL GUARDS
Place the corresponding guard over the light and
into the 3 bolt slots. With a 4mm Allen key, secure
the guard and light with 3 of the included button
head bolts. …………………………………………………………..
Repeat on the opposite side.
FB21120
Jeep® ’18-Current JL Wrangler & ’20 JT Gladiator
Headlight Guards
2
4) REASSEMBLE YOUR VEHICLE
Begin reassembling your vehicle by starting with
pressing and snapping your grill back into place.
Replace the body clips.
Close the hood.
5) ENJOY YOUR NEW FISHBONE OFFROAD
HEADLIGHT GUARDS!
  • Page 1 1
  • Page 2 2
  • Page 3 3

Fishbone Offroad FB21120 Installation guide

Brand
Fishbone Offroad
Model
FB21120
Type
Installation guide
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents