Portable Audio CD Player V30M30_IM_EN_05272009
www.jWIN.com - 3 -
OPERATING INSTRUCTIONS
Playing a Disc
Be sure to reduce the volume before plugging in or unplugging the
headphones.
1. Plug the headphones (included) into the HEADPHONE jack.
2. Press the CD OPEN button to open the CD compartment.
3. Hold the disc with the label side up and press it in until it “clicks” into
place.
4. Close the disc compartment, press the PLAY / PAUSE XII button.
5. Adjust the volume as desired.
6. To temporarily stop playback, press the PLAY / PAUSE XII button.
The elapsed playing time flashes in the display. Press the PLAY /
PAUSE XII button again to resume playback.
7. To stop play, press the STOP / POWER OFF button. The power will
turn off automatically when the entire disc has played or after
approximately 30 seconds of inactivity.
Programmed Play
The tracks on the disc can be programmed for playing in any order.
1. Press the STOP / POWER OFF button during playback.
2. Press the PROG Button and select the desired track by pressing the
or buttons, and then press the PROG button again to program
the track.
3. Repeat Step 2 for all tracks to be programmed.
4. Press the PLAY / PAUSE XII button to begin the programmed
playback.
NOTE: When playback stops, the programming will be erased.
5. To cancel programmed playback, press the STOP / POWER OFF
button.
Repeat Playback
• To play a single track repeatedly, press the MODE button repeatedly
until “
” appears. Press the PLAY / PAUSE XII button if playback
is stopped.
• To play the entire CD repeatedly, press the MODE button repeatedly
until “
” appears. Press the PLAY / PAUSE XII button if
playback is stopped.
• To cancel the Repeat Function, press the MODE button repeatedly until
“
” or “ ” disappears.