SHANGRI-LA SHANGRI-LA SLVICFABOKA Victoria Bed, SLVICFABOKA Victoria Bed User guide

  • Hello! I have carefully gone through the user guide for the SHANGRI-LA bed models SLVICFABOKA, SLVICFABPKA, and SLVICFABSKA. The document provides detailed instructions on how to assemble the bed, including all the necessary steps and the included components. I am ready to answer your questions about it.
  • What size are the screws used to assemble the bed?
    What are the components included in the bed package?
    Which tools are needed for assembly?
VICTORIA BED
KING
SLVICFABOKA, SLVICFABPKA, SLVICFABSKA
Hardware
A Headboard (x1)
B Footboard (x1)
C Side rail (x2)
D Long slat (x2)
E Bottom support (x4)
F Leg (x4)
G Short slat (x39)
H Double-sided cap (x26)
I Single-sided cap (x26)
1 30mm M8 screw (x8)
2 20mm M8 screw (x8)
3 25mm M8 screw (x8)
4 35mm M6 screw (x8)
5 M6 nut (x8)
6 Allen key (x2)
COMPONENTS
Step 1: Align the two holes of the bracket on the side rail (C) with the end of the headboard
(A). Insert and tighten a 30mm M8 screw (1) through each hole of the bracket using the
Allen key (6).
Once secured, attach the bracket on the other end of the side rail (C) to the footboard (B)
the same way, then repeat with the other side rail (C) on the other side of the bed.
ASSEMBLY
Step 2: Attach the legs (F) to the corners of the bed, securing them onto the headboard (A),
footboard (B) and side rails (C) using the 20mm M8 screws (2) and Allen key (6).
Step 3: Insert the long slats (D) into the headboard (A) and footboard (B). Secure by
inserting and tightening 25mm M8 screws (3) using the Allen key (6).
Step 4: Align the holes on the bottom supports (E) under the holes marked on the vertical
slats (D). Insert and tighten 35mm M6 screws (4) through the holes using the Allen key (6).
Insert and tighten a M6 nut (5) on the underside of the bottom supports (E) using the
wrench (7).
Step 5: Connect three short slats (G) using the single and double-sided caps (I,H) as shown
below. This will create a slat assembly. Repeat this process until you have 13 slat
assemblies.
Place and align one slat assembly’s single and double-sided caps (I, H) onto the bed with
the marked dots on the side rail (C) and long slats (D).
Repeat with the remaining slat assemblies.
Assembly complete.
x13
Need more information?
We hope that this user guide has given you
the assistance needed for a simple set-up.
For the most up-to-date guide for your product,
as well as any additional assistance you may require,
head online to help.kogan.com
1/8