Standard high back seat (13401.XX)
Standard low back seat (13400.XX)
1976 - 2002 CJ - Wrangler
Installation Instructions
_________________________________________________________________________________
Included components:
(1) Lower seat section
(1) Upper seat section
(4) Hex Head Bolts
(4) Lock Washers
Seat Assembly:
Step (1)
Insert upper seat section to lower seat section through
slots located on the back side of lower section.
Step (2)
Fold upper section back into upright position.
Turn seat over and pull plastic retainer channel away.
Step (3)
Install all 4 bolts and washers(DO NOT TIGHTEN)
After all bolts have been installed tighten and reinstall
plastic retainer channel as shown above.
Seat installation instructions:
Step (4) Remove old seat from riser by removing
4 bolts. Save these bolts as they will be
reused later.
Step (5) Remove sliders from old seats by removing
4 bolts. Save these bolts as they will be
reused later.
NOTE: To access the rear 2 bolts push slider arm
down and move slider forward.
Step (6) Place sliders onto new seats. Reuse spacers
from the old seat to align the slider.
Step (7) Fasten slider to the new seat using the 4
bolts saved from step 5
Step (8) Carefully place slider back onto seat riser and
fasten with 4 bolts saved from step 4
Pg.1
-
1
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Other documents
-
Smittybilt 44801 Installation guide
-
Minimizer LONG HAUL Series User manual
-
Kawasaki Z900 Assembly & Preparation Manual
-
Yamaha DRAG STAR XVS1100A Owner's manual
-
Invacare Twister User manual
-
Bowflex ULTIMATE 2 Specification
-
K2 Bike Chubby User manual
-
Buell Buell Blast P3 2001 User manual
-
APRILIA PEGASO 650 STRADA Service Station Manual
-
Trixter X-Bike User manual
