Thermo Pet Cot
Care & Instructions
Thank you for purchasing the Thermo Pet Cot by K&H Pet Products. When used correctly, your Thermo Pet
Cot should provide years of hassle free warmth for your pet. This product is intended for indoor use. Its unique
heating system is designed to become warm, not hot. The heater can also be removed and stored in the off-season!
ASSEMBLY INSTRUCTIONS
USE INSTRUCTIONS
Read all instructions carefully. This is an electrical
product, pay special care to IMPORTANT SAFEGUARDS.
When using electrical appliances, basic safety precautions
should always be followed including the following:
IMPORTANT SAFEGUARDS
WARNING: This is an electrical product. Read all directions and precautions carefully before operating. Failure to properly follow
all directions and instructions may lead to electrical shock or re which could cause serious bodily injury.
Read all instructions.
•
To protect against electrical hazards, DO NOT immerse cord,
plug or appliance in water or other liquid.
•
DO NOT operate any electrical appliance with a damaged cord
or plug, or if the appliance malfunctions or has been damaged
in any manner. RETURN all malfunctioning appliances to the
factory for examination.
•
When using this product, make sure your pet has the option of
sleeping on or OFF the bed.
•
SAVE THESE INSTRUCTIONS FOR YOUR USE.
•
CORD MUST EXIT towards the back of bed, away from normal
travel of pet.
•
A liner must separate the pet bed warmer from the stufng
material.
•
DO NOT use appliance for other than its intended use.
•
ALWAYS unplug from outlet when not in use.
•
DO NOT PUNCTURE HEATER FOR ANY REASON.
•
For use with 110-120 volt AC ONLY.
•
Close supervision is necessary when used by or near children.
•
Make sure your pet’s bed has a removable outer lining
with a zipper or other means of closing and opening.
1
Carefully position your pet bed warmer between the outer
and inner lining and close the opening so your pet cannot
remove the heating pad. When in use, check the pad to
ensure proper positioning.
2
Turn the bed so the cord is exiting the back of the bed,
away from the normal path traveled by your pet.
3
When cleaning the bedding, unplug and remove the pet
bed warmer so you do not subject it to being immersed in
liquids or cleaners.
4
REV0_06-08-18
Made in China
K&H Pet Products, Central Garden & Pet
Colorado Springs, CO
www.khmfg.com | (719) 591-6950
Fold out the cover so that it’s at.
Be sure all 4 frame tubes are threaded through the
sleeves sewn along edges of the cover.
Insert all 4 frame tubes into the nylon supports.
Turn cot on its side and insert the K&H pet bed
warmer into the
enclosure making
sure that the cord
exits out the back
corner of the cot.
Close the zipper
all the way to
where the cord exits
the enclosure.
TIP: Cot can be
used in the summer
by removing heater.
1
2
3
4
Care Instructions:
Wipe clean with a damp cloth.
Machine wash gentle, line dry.
/
