AV:Link HDM-3EXCU 100M + USB HDMI UHD Extender User manual

HDM-3EXCU 100M + USB HDMI UHD Extender
AV:Link
Brand
AV:Link
Model
HDM-3EXCU 100M + USB HDMI UHD Extender
Category
Console extenders
Type
User manual

The AV:Link HDM-3EXCU 100M + USB HDMI UHD Extender allows you to extend your HDMI signal up to 100 meters over a single CAT.6A U/FTP cable. It supports resolutions up to 4k2k@60 4:4:4 and HDR, and is HDCP compliant. The extender also features USB 2.0 extension, allowing you to connect USB devices such as keyboards, mice, and flash drives to your remote display. With built-in IR extension, you can control your source device from the remote location.

The AV:Link HDM-3EXCU 100M + USB HDMI UHD Extender allows you to extend your HDMI signal up to 100 meters over a single CAT.6A U/FTP cable. It supports resolutions up to 4k2k@60 4:4:4 and HDR, and is HDCP compliant. The extender also features USB 2.0 extension, allowing you to connect USB devices such as keyboards, mice, and flash drives to your remote display. With built-in IR extension, you can control your source device from the remote location.

HDMI
UHD EXTENDER
HDM-3EXCU 100M + USB
HDM-3MXCU 40M + USB
HDM-3MXC 40M
(Local or Remote)
USER MANUAL V1.0
Package Contents-
2x HDM-3EXCU or HDM-3EXC or HDM-3MXCU or
HDM-3MXC Unit
1x User manual
1x USB Micro B to Type A Cable ( HDM-3EXCU
HDM-3MXCU Only )
1x IR Receiver Cable
1x IR Blaster Cable
2x Terminal Blocks 3P
1x Power adapter DC 12V with lock
Anything missed, please contact with your vendor.
-1-
Features
Through the HDMI Extender, you can use one BD or
UHD Source to display identical image and extension
of HDMI signal up to 100 Meter on UHD TV.
HDCP Compliant
Supports 3D pass-through
Support RS-232(Bi-direction transfer)
Supports all frequency band IR extension control
One CAT.6A U/FTP cable extension *Note
Supports UHDTV up to 4k2k@60 4:4:4 & HDR
HD-BaseT technology
USB 2.0 Extender
Supports Power over Cable ( POC ) *Note
Specifications
Function HDM-3EXCU HDM-3MXCU HDM-3MXC
HDMI In
Connector
HDMI A-Type Female x 1
HDMI Out
Connector
HDMI A-Type Female x 1
RJ-45 Connector
1
RS232
Terminal block (TXD GND RXD)
IR OUT
3.5
ψ
Stereo Jack x 1
IR IN
3.5
ψ
Stereo Jack x 1
USB Micro B
USB 2.0 ( Host
or Device )
USB 2.0 ( Host
or Device )
NA
DIP SW
Setup USB/IR/Gender Function
Max. Resolution
4k2k 60fps 4:4:4 / 8K 30fps 4:2:0
Cable Distance
Cat.6A
U/FTP 100M
Cat.6A
U/FTP 40M
Cat.6A
U/FTP 40M
Power Adapter
(Min.)
DC 12V with lock
Housing
Metal
Weight
228 g
Dimensions
107.2 x 69 x 20 mm (LxWxH)
LOCAL FRONT VIEW
1. DIP SW : USB/RS232/Gender Device Setup
2. IR IN
3. IR OUT
4. LED : Power/Mode/LINK/Gender/HDMI TX/HDMI RX
5. RS232 : TX/GND/RX
-2-
LOCAL REAR VIEW
1. Power Jack
2. LINK : HDBT TX/RX
3. HDMI IN
4. HDMI OUT
5. USB : Host/Device ( 3EXCU & 3MXCU Only)
Installation
1. Connect the HDMI extension cable between the BD and
the “HDMI IN” port of HDM-3EXCU Local TX Device.
2. Connect the HDMI extension cable between the UHDTV
and the “HDMI OUT” port of HDM-3EXCU Remote RX
Device.
3. Connect the CAT.6A cables between the TX “LINK” port
and the RX “LINK” port of extender.
4. Connect the power cord on the extender.
5. Turn on the BD UHDTV and Power on HDM-3EXCU.
IR Receiver Cable Directions:
Put it into the Device “IR IN” port and place the IR Receiver
Cable, so that you can point to it easily with your IR remote
extension controller.
IR Blaster Cable Directions:
Plug IR blaster cable plug into Device “IR OUT” port, It sits
in front of the BD receiver’s IR sensor, which is located on
the front-panel.
RS232:
1. Connect RS232 signal to RS232 TXD/GND/RXD Port
on HDM-3EXC TX and RX Device.
2. RS232 baud rate support to 115200.
USB
1. Setup the HDM-3EXCU Dip SW to USB Host or
Device.
2. Connect Cable between the PC and HDM-3EXC USB
Host Port.
3. USB Micro B to Type A Cable Connect to HDM-3EXCU
USB Device Port and Plug in USB Device on Cable
Type A Port.
4. Support Keyboard/Mouse/Flash Drive and many more
USB 2.0 Devices up to 350Mbps data rate.
-3-
Dip Switch Setup
(HDM-3EXCU or HDM-3MXCU) (HDM-3MXC)
Led Status
Power
ON
Power On
OFF
Power Off
Mode
Blinking
FW loaded and running
LINK
ON
HDBT LINK
Blinking
HDBT LOW POWER MODE
OFF
NO HDBT LINK
Gender
ON
HDBT TX
Blinking
HDBT RX
HDMI TX
ON
HDMI With HDCP
Blinking
HDMI With Out HDCP
OFF
NO HDMI Video
HDMI RX
ON
HDMI With HDCP
Blinking
HDMI With Out HDCP
OFF
NO HDMI Video
Additional Options
Select any additional options you may require.
1. IR Receiver Cable
GND
+V
Sig
-4-
2. IR Blaster Cable
NC
P+
N-
Technical Specifications Output
Signal
Signal
Pin #
Signal
TMDS Data 2+
11
TMDS Clock Shield
TMDS Data 2 Shield
12
TMDS Clock -
TMDS Data 2-
13
CEC
4 TMDS Data 1+ 14
Reserved
(N.C. on device)
TMDS Data 1 Shield
15
SCL
TMDS Data 1-
16
SDA
TMDS Data 0+
17
DDC/CEC Ground
TMDS Data 0 Shield
18
+5 Power
TMDS Data 0-
19
Hot Plug Detect
TMDS Clock+
Wiring Information & Coding
Conductor
Identification
RJ45 Pin
Assignment
Color Code for
Conductor
Pair 1
5
White-Blue
4
Blue
Pair 2
1
White-Orange
2
Orange
Pair 3
3
White-Green
6
Green
Pair 4
7
White-Brown
8
Brown
-5-
Note
1. The actual transmission quality of CAT6A U/FTP cable
will affect the maximum transmission distance.
CABLE COMPOSITION: 23AWG*4P CAT6A U/FTP
500MHZ Attenuation : 39 (dB/100m)
2. The POC will be attenuated by the actual matching of
the CAT6A Cable, which affects the stability of the
remote power supply.
Reducing the length of the wire or increasing the CAT6A
AWG can increase the stability of the remote power
supply.
© AV LINK GROUP LTD., All rights reserved.
Trademarks:
All the companies, brand names, and product names
referred to this manual are the trademarks or registered
trademarks belonging to their respective companies.
-6-
  • Page 1 1
  • Page 2 2

AV:Link HDM-3EXCU 100M + USB HDMI UHD Extender User manual

HDM-3EXCU 100M + USB HDMI UHD Extender
AV:Link
Brand
AV:Link
Model
HDM-3EXCU 100M + USB HDMI UHD Extender
Category
Console extenders
Type
User manual

The AV:Link HDM-3EXCU 100M + USB HDMI UHD Extender allows you to extend your HDMI signal up to 100 meters over a single CAT.6A U/FTP cable. It supports resolutions up to 4k2k@60 4:4:4 and HDR, and is HDCP compliant. The extender also features USB 2.0 extension, allowing you to connect USB devices such as keyboards, mice, and flash drives to your remote display. With built-in IR extension, you can control your source device from the remote location.

Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Other documents