eLEDing EE812PPL(OP) User guide

eLEDing
Brand
eLEDing
Model
EE812PPL(OP)
Category
Power banks
Type
User guide

This manual is also suitable for

Thank you for choosing eLEDing!
It is important that you read this set-up instruction before installing
Any questions or issues, please contact us before returning
Our goal is 100% customer satisfaction
Please post your positive feedback on the web-stores
We appreciate your business! Thanks again!
EESGI: [email protected] 1-877-579-3889 USA or 626-579-3889 (M-F, 10:00am to 5:00pm PST)
(Refer Page 2 for detail of Installation)
INSTANT DISCOUNT COUPON for Purchasing any of these High Performance Solar Lights
Model: EE812PPL
(WP)
(BP)
Rev. EE812PPL 12072015 Page 1
Redeem the coupons by calling: (877)579-3889, sales@eesgi.com, www.eleding.com
EE818WDC
Equivalent to 100W+ Halogen Lamp or
200 pieces traditional LED matrix illuminators
Dusk to Dawn continuous illumination
EE860plus
Equivalent to 60W+ Standard Lamp
Upgraded dual operating SMART modes
Dusk to Dawn continuous illumination
EE814WDC
Equivalent to 60W+ Halogen Lamp or
100+ pieces traditional LED matrix illuminators
Dusk to Dawn continuous illumination
Notes:
The back solar panel charges the battery and it must have at least 4 hours of direct sunshine each time for max charging.
Use only DC 5V/1-2A charger if charging from an AC source or PC USB port when charging the product with the USB
power supply .
Handle it with care to avoid damaging or breaking the solar panel. The solar panel must be kept clean from dust.
The battery needs to have a complete charge and discharge at least once every three months.
The green indicator lamp will light up when the solar panel is fully charged.
This product is weather resistant but not water-proof. Do not allow it to be submerged in water or covered with water.
Rev. EE812PPL 12072015 Page 2
Contact Info: (877)579-3889, [email protected], www.eleding.com
eLEDing EE812PPL Quick Set-up Reference
Product instruction:
Thank you for choosing our Integrated Solar/Hybrid powered portable charger and LED light model: EE812PPL. This
outdoor or indoor portable solar light can be used for a wide variety of recreational and work lighting needs. It can also
be used as a power bank to charge most digital mobile devices. Please read the instructions carefully before using.
The solar panel must receive at least 4 hours of direct sunshine to fully charge the battery before using. It is highly
recommended that the light be kept fully charged as much of the time as possible by direct sunlight. A DC power
charger (
DC 5V/1-2A) plugged into the “Charging Port” can also be used to charge this light.
Product functions:
1. To use as a lamp or flashlight press the “Main lamp switch” button. Momentarily afterwards it will light up and provide
continuous illumination: LOW (up to 32hrs), MIDDLE (up to 16hrs) and HIGH (up to 10hrs). Press the “Main lamp
switch” button to increase the levels of brightness and to turn the light OFF.
2. To use as Power Bank, connect any standard USB cable to the “USB Port”. A constant red light will appear in the
“Indicator lamp” and it will turn green when the attached device is fully charged. A flashing red light means the Power
Bank battery is low and the the light unit needs to be charged. The USB cable must be disconnected each time after
charging a device and then re-connected again to begin charging a device.
  • Page 1 1
  • Page 2 2

eLEDing EE812PPL(OP) User guide

eLEDing
Brand
eLEDing
Model
EE812PPL(OP)
Category
Power banks
Type
User guide
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents