1. Lay out all parts on the ground . Get support bracket (B) connected with one side panel (A) ,
insert the side panel into the tube of support bracket , hole to hole alignment and tighten
screws by hand only (Figure 1) . Same way for the other side panel (A) assembled (Figure 2) .
2. Tighten all the screws by screwdriver , make the log rack stand upright , now it's ready for
use (Figure 3) .
Figure 3
WARNING
:
It is important that your rack is assembled correctly. If the product is assembled or used
incorrectly, it could become unstable and collapse, possibly causing injury.
Rectangular Heavy Duty Log Rack
SKUs:899951/899952